Belkin Omniguard-1100 replacement UPS battery set AGM sealed lead
Replacement Belkin Omniguard-1100 computer UPS battery pack, valve regulated sealed lead acid rechargeable absorbed glass mat batteries that will not spill offered at low prices direct from warehouse
Here you will find we have hopefully supplied sufficient detailed information to help you make an informed decision on the purchase of a new set of batteries for your Belkin Omniguard 1100, the electric energy that is required for this device to function is stored onboard in the batteries, it takes the mains supply and smoothes out spikes as pushes it through the batteries and is powered by 12-volt cells, this system comes with 2 x 12v batteries and that is what we are offering on this page, these rechargeable batteries benefit from being VRLA with AGM technology (more information about the chemistry qualities will be found below) they are recyclable and very environmentally friendly, see out recycle page for more details of this aspect
- Belkin Omniguard 1100 battery
Installing the new batteries in to the UPS is not a difficult job, certainly well within the reach of most people, you can refer to your user manual for the method if required, they are designed to be replaced, the ones we send to you will be almost fully charged but the UPS will still complete a service charge upon installation, so it will follow that there will be a short period of time where you do not have the full runtime protection that your UPS could possibly offer you until it has completed this operation, you probably just want to install and leave the system to its devices but its best to run the system without a load to so it can properly reset
It would not be unreasonable to hope for a 2 to 5 year life span of batteries in the UPS, this will however rely on how they are used, make sure the vents are not restricted it must have good ventilation, the batteries will get hot in general use, if they are allowed to run hot all of the time it will shorten life span, If you can keep the constant load below 40% the batteries will end up lasting longer, a high load will be at the expense of the overall life expectancy of the cells
These batteries are sealed lead and valve regulated or VRLA and benefit from advanced AGM technology, this means they will not spill so can be mounted on the side in a UPS without any fear of leakage, they can be used in rack or tower modules, they are not-hazardous so safe for use in mission critical environments including busy data centres or medical back up
Please note, you should use the information we have supplied on this page is only a guide, we have tried to assist you in getting the correct batteries for your UPS system, there are so many very similar codes, if you are not sure you should check what you have before ordering, this will also give you the opportunity to see how easy it is going to be to change the batteries, if you look very closely at the product code on your UPS then you shouldn't go wrong, if you still are not sure study the dimensions of the battery as these are also listed on this page. The batteries are recyclable, more information on recycling can be found at the foot of this page.
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = sealed lead, AGM, VRLA
Hot swap capable
We are offering a total of 2 recyclable lead batteries for the Belkin Omniguard 1100 UPS the physical dimensions are as follows
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5
As an easy upgrade path we are able to offer this battery size as a 9ah version, it will slip straight into the same cavity but offer you a longer runtime, the link to this will be a little bit further below
