Sigma 6000 medical infusion pump battery sealed lead 3.2-amp VRLA.
Replacement Sigma 6000 medical infusion pump battery, 12-volt non-spillable sealed lead acid rechargeable batteries, they are safe to use indoors and portable devices, 3.2-amp hour at low prices direct from warehouse.
This page is dedicated to offering detailed information for your consideration for a replacement battery pack for a Sigma 6000 medical infusion pump they are 12-volt 3.2-amp hour, as they are AGM and VRLA they are safe to use indoors and will not leak, likewise suitable for portable devices, they are of course rechargeable.
- Sigma 6000 medical infusion pump battery
These AGM batteries require no maintenance, no need to top up fluid, they will not leak and safe to use indoors as they are not-hazardous, they are valve regulated sealed lead acid or VRLA, safe to use in portable equipment.
Please check your the codes on your old battery carefully first before ordering this compatible one, for the few minutes it going to take you it will be worth it, the information here is only a guide
Voltage = 12-volts
Capacity = 3.2Ah @ 20Hr
Chemistry = AGM, VRLA.
We are offering a total of one recyclable lead batteries for the Sigma 6000 medical infusion pump here is the dimensions of a single battery
Length = 134mm or 5.27-inches
Width = 67mm or 2.63-inches
Height = 61mm or 2.4-inches
Standard push fit flat terminals - 4.75mm or 0.187 inch.
This battery will come out to you almost fully charged, upon receipt fully charge it before using and again after every use, it is important that you do not try to run down the cells, if you are not using for several weeks at a time then a top up charge every four weeks will be required to keep the cells in good order, keeping your new sealed battery fully charged will help it last longer.
