Cutter-Labs-5000 Infusion Pump 6v 3.2ah battery replacement sealed
Replacement Cutter-Labs-5000 Infusion Pump battery pack, rechargeable small 6v valve regulated sealed lead acid mobility batteries rated at 3.2ah non-spillable suitable for portable equipment
Below you should find we have listed most of the relevant information that you would need to help assist you in the renewal of a compatible battery for your Cutter Labs 5000 Infusion Pump, these 6-volt batteries are often seen in portable medical equipment or back up in alarm systems, they are deep cycle capable with a energy storage of 3.2-amp hours, which are, as would be of course be required, rechargeable, they are safe to use indoors they will not spill, non-hazardous, AGM and VRLA construction of cells, much more information about the qualities of these unique chemistries can be found below
- Cutter Labs 5000 Infusion Pump battery
This sealed lead battery that you obtain from us will be almost fully charged, but you should still charge them fully before first use, however if it's a battery backup for something that's always connected to the mains with its own built in charging circuit like a monitor or maybe a alarm system then you do not need to charge it first as the system will do that for you, there should be no need for many hours, it will probably not take very long at all as its almost fully charged already, just until your charger indicates they are ready, this will of course depend on the charger capabilities, this first step is important so please do ignore it, unless of course as otherwise stated above, do not use without this initial charge, doing so can shorten expected life span
While is not something that most will even notice but if being used in a portable piece of equipment it could take a number of charges and corresponding use in the device before a full capacity charge is reached, this is a normal part of the conditioning process, after you have used your more portable equipment you should get a charge back into it as soon as you are able, do not leave it sitting around in a partially discharged state for any longer than absolutely necessary, do not try to attempt to fully discharge the batteries, it will not rejuvenate them, in fact the opposite, it will reduce the lifespan and cost you money in the long run, if for any unforeseen reason they is an extended period where you are not using the batteries make sure they are fully charged first, then recharge every four weeks but do not leave on the charger for more than 24-hours
The battery type that we are offering here is VRLA and AGM, they need no maintenance, no topping up of fluids, the acid is suspended within a glass matting, they are sealed lead acid and valve regulated with AGM technology, they are not-hazardous and safe to use around the home or in portable devices well as travelling
We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery, take note of the dimensions and anything written on the side of them, we have included the size below so you can double check, these 6v 3.2ah batteries are constructed mainly from lead which is easy to recycle and transform into another product so therefore environmentally friendly, more information regarding recycling will be found at a link at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = Pb, sealed lead, VRLA, AGM
In this pack there are a total of 1 quality batteries for the Cutter Labs 5000 Infusion Pump the physical dimensions of each battery is
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
