MLA128080 rechargeable 6-volt 3.2ah battery replacement AGM VRLA
Replacement MLA128080 battery pack, rechargeable compact 6v 3.2ah sealed lead acid, safe non-spillable so can be used in portable equipment, valve regulated VRLA batteries with advanced AGM technology at low competitive cost
Below you will hopefully find we have entered all of the relevant details for you to decide on the purchase of a new compatible battery you will require for the MLA128080, this type of battery is often seen in portable medical equipment as well as alarm systems as a emergency battery backup, they can store 3.2-amp hours of energy in the 6-volt cells and capable of deep cycling, they are of course rechargeable, very important requirements in this type of installation, they will not spill and not-hazardous so safe to be handled and for use indoors or in portable equipment, the cells are AGM and VRLA, more information about the qualities of this sort of chemistry can be found below
- MLA128080 battery replacement
The battery pack that you receive from us will be almost fully charged, but you should still charge them before first use, this will not be necessary only if being fitted in something that has its own built in charger that is always connected to the mains like an alarm system which will do the job for you, you only need to complete the charge until the charger indicates that its ready, it probably will not take long but it is very important so not a step you should overlook, you may well just want to fit them and use the equipment, but do try not miss this first step, if needed that is, it's worth waiting until the first charge has completed and it may well contribute to over life span
It's not something that most will even notice but if being used in a portable device it may take a few charges and use in the equipment before a full capacity charge can be reached, it's all part of the normal conditioning process, when you have used your portable device then ensure you put the batteries back on charge, you do not want to allow them to sit in a partially discharged state, discharging the batteries fully will only reduce their life expectancy, you cannot kick start this kind of battery in that way, it will do them no good and will cost you money in the long run, these batteries need to be kept charged, so if there is any reason where they are not be used then ensure they are charged beforehand and then every 4-weeks, but do not leave on a charger for more than 24-hours
These 6-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or in portable equipment without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not hazardous
Please note you should use all the information on this page only a guide, while we have tried very hard here to assist you in getting the correct battery, it should be noted that there are many very similar codes, if you are not sure you should always double check what you have before ordering, this may also give you the opportunity to see how easy it is going to be to change them, take note of the dimensions and anything written on the side of them, all the physical sizes are listed on this page, these 6-volt 3.2ah batteries are made mainly of lead which is deemed easy to be recycled, more information about recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = sealed lead acid, VRLA, AGM
There is 1 quality batteries for the MLA128080 the physical dimensions are as follows
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
