Emerson Liebert PowerSure PL600 UPS battery replacement pack VRLA
Replacement Emerson Liebert PowerSure PL600 rechargeable batteries, valve regulated sealed lead acid non-spillable safe UPS system battery pack, absorbed glass mat AGM cells low competitive price
Please find the information on this page to help you make a decision for a new set of batteries for the Emerson Liebert PowerSure PL600, the electric energy that is required for this device to function is stored onboard in the batteries, it takes the mains supply and smoothes out spikes as pushes it through the batteries and is powered by 12-volt cells, this system comes with 2 x 12v batteries and that is what we are offering on this page which of course as would be required, rechargeable, they are safe to use, not-hazardous, not-spillable AGM and VRLA type batteries, more detailed information about the fine qualities of them can be found below
- Emerson Liebert PowerSure PL600 battery replacement
Installing the batteries is comparatively easy procedure if in any doubt refer to your manual for the process, they will come out to you almost fully charged but the system will still go through a service charge upon firing up, so it will follow that there will be a short period of time where you do not have the full runtime protection that your UPS could possibly offer you until it has completed this operation, if you have the opportunity, maybe of an evening, it will be best to run the system without a load to start so it can properly reset itself to the new energy level
It would not be unreasonable to hope for a 2 to 5 year life span of batteries in the UPS, this will unfortunately be very dependent on the general conditions its put under, good ventilation is always important, so often they are used as a book shelf, If you can keep the constant load below 40% the batteries will end up lasting longer, a high load will be at the expense of the overall life expectancy of the cells
The battery type is the preferred AGM or absorbed glass mat construction, they are also valve regulated, this means they can be used in tower or rack mounted UPS systems without the fear of any leakage, they will require no maintenance throughout their entire life span and they are not-hazardous deemed safe for use in busy data centres, medical back up and of course the general home office
Check the code on your system carefully so you order the right battery set, so many of the codes are very similar so it's easy to make a mistake, if still unsure have a look at the batteries you have already, the dimensions will help eradicate issues as these are also listed on the page, the batteries are made mainly from lead and recyclable, more information on recycling can be found at the foot of this page.
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = Pb, sealed lead, VRLA, AGM
Hot swap capable
In this pack there is 2 ready to install batteries for the Emerson Liebert PowerSure PL600 UPS the physical dimensions are as follows
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5
As an easy upgrade path we are able to offer this battery size as a 9ah version, it will slip straight into the same cavity but offer you a longer runtime, the link to this will be a little bit further below
