Eaton Powerware PW5119-1000i UPS battery pack replacement VRLA
Replacement Eaton Powerware PW5119-1000i rechargeable batteries, valve regulated sealed lead acid non-spillable safe UPS system battery pack, absorbed glass mat AGM cells low competitive price
Please find the information on this page to assist you in the renewal of batteries for your Eaton Powerware PW5119-1000i, the system uses batteries to filter the input electricity and output a clean supply to protect your equipment behind it they are 6v cells, and comes with 4 x 6-volt batteries and that is what this offer is for which are rechargeable they are the recommended non-spillable safe AGM and VRLA type of cell which would be required in this kind of machine
- Eaton Powerware PW5119-1000i battery replacement
The batteries will come out to you almost fully charged, but the system will still want to finish off the full charge, so there will be a period of time where you do not have the full protection that it can offer until it has completed this operation, if you can its best to do this initial charge without any load, we know this may not be convenient in a lot of installations but that is best advise
Batteries in this kind of installation will have a life span of between 2 to five years, this will be very dependent on the use and the way the system is stored, good ventilation, if it's in a office do not use it as a book shelf, keeping the load low will extend the life span, in a ideal world below 40%, they are so often run to the edge of their capabilities, while they may be able to do it its reducing the life span
The cells are absorbed glass mat or AGM, they are also valve regulated sealed lead acid or VRLA, this is the recommended type of battery for this installation, they will not leak if mounted on the side so safe to be used in tower or rack mountable configuration with fear of spillage in mission critical applications as well as the home office
Check the code on your system carefully so you order the right battery set, the batteries are made mainly from lead and recyclable, more information on recycling can be found at the foot of this page.
Voltage = 6-volts
Capacity = 10Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
We are offering a total of 4 ready to install batteries for the Eaton Powerware PW5119-1000i the physical dimensions are as follows
Length = 151mm
Width = 51mm
Height = 94mm
Battery layout - from chart below = 1
Hot swap capable, no maintenance required
