Liftmaster LA250EVK LA300EVK battery replacement for gate opener.
Battery pack replacement compatible with Liftmaster LA250EVK and LA300EVK gate opener, easy to replace and install yourself at low costs.
The Liftmaster LA250EVK and LA300EVK are units required for gate automation. Both units depend heavily on a pair of 12v batteries to deliver that consistent push and release action gates rely on. Once the originals begin to decline, users often notice slower travel, reduced torque on heavier gates, or intermittent pauses, and replacing the power pack is typically all that is needed to restore the system back and getting the gates moving again.
You will receive a pair of high quality twelve volt sealed lead batteries to be installed into your Liftmaster LA250EVK and LA300EVK opener kit. Please reuse all your existing wires but if you do require more, please contact us.
- Liftmaster LA250EVK battery
- Liftmaster LA300EVK battery
Two batteries in this set for the Liftmaster LA250EVK and LA300EVK.
To keep the pair feeling fresh for longer, it helps to let the system reach a full charge now and then rather than cutting power too early. Keeping the housing dry stops heat and moisture from shortening their life, and if the gate won’t be used for a while, isolating the power keeps slow drain in check. With a bit of basic care, this compatible pair of batteries should carry both models without fuss for years.
Voltage: 12v x2
Chemistry type: AGM, VRLA, Pb.
Capacity: 2.2ah.
Terminals: 4.75mm.
The physical size of each battery in this pack of two for the Liftmaster LA250EVK and LA300EVK is as follows:
Length = 70mm or 2.76-inches
Width = 47mm or 1.85-inches
Height = 97mm or 3.86-inches.
