PB28D PL1 PL2 PL3 SGLD 6-volt 7ah battery replacement AGM VRLA
Replacement PB28D PL1 PL2 PL3 SGLD 6-volt 7ah sealed lead battery pack, rechargeable system valve regulated batteries, VRLA and AGM, they will not spill, safe to be mounted on the side at low competitive cost
Below you will find we have listed the relevant information to help you consider the decision on the purchase of a new batteries to replace the PB28D PL1 PL2 PL3 SGLD compatible batteries which is 7amp hour and 6-volt batteries, use they are capable of deep cycling and rechargeable, two very necessary requirements in this type of installation, also they are non-spillable and not-hazardous so safe to be handled and for use indoors, the cells are AGM and VRLA of which more information can be found further down the page
- PB28D PL1 PL2 PL3 SGLD battery replacement
The batteries you receive from us will be almost fully charged, but you will still have to charge them before first use, an over rider to this would be if it's going into something with its own built in always connected power supply which will complete the job for you, you do not need to leave it on for hours on end, it will probably not take very long at all depending on the charger, just until the charger has indicated that it has finished, do not just install and go without this initial charge, doing so can shorten expected life span, it's well worth doing
it may well take a number of full charges and alternating use in your equipment for the battery to condition and be able to take a full capacity charge, this is quite normal, ensure that after every use that you put the batteries back on charge, letting them sit in a partially discharged state is not wise, discharging the batteries fully will only reduce their life expectancy, it will do them no good and will cost you money in the long run, they may be protracted periods where the batteries are not being used, if this is the case ensure they are fully charged first, then top up every four weeks but do not leave on a charger for more than four weeks
These batteries are deep cycle capable, which is essential in this type of application, the VRLA and AGM cells will not leak and not-hazardous so suitable for portable equipment, there is no maintenance required, except of course charging which we have covered on earlier on this page, both VRLA and AGM
Check the code on your old battery carefully to ensure you are ordering the correct one as many of them have very similar names of codes, if in doubt you could check the dimensions of the batteries and take note of anything that may be written on the side of them, the size of the batteries are also specified below so you can confirm, these batteries are made mainly of lead which is easy to be recycled, more information about recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 7Ah @20Hr
Chemistry = VRLA, AGM
This set contains 1 quality batteries for the PB28D PL1 PL2 PL3 SGLD the overall size of the batteries are
Length = 151mm or 5.94-inches
Width = 34mm 1.33-inches
Height = 94mm or 3.7-inches
Battery layout - from chart below = 1
