Imed mini PC4 rechargeable 6-volt 3.2ah battery replacement AGM
Replacement Imed mini PC4 batteries, rechargeable valve regulated sealed lead 6-volt 3.2-amp hour compact non-spillable battery, can be used in portable devices, available at low competitive price direct from warehouse
Below printed on this page you will find we have listed detailed information which should be sufficient to help you consider the decision to buy new compatible replacement battery for your Imed mini PC4, this type of battery is often seen in portable medical equipment as well as alarm systems as a emergency battery backup, they can store 3.2-amp hours of energy in the 6-volt cells and capable of deep cycling, these are of course as would be needed in such installations rechargeable, they are non spillable, safe and not-hazardous so safe to be handled, stored and used indoors, the cell structure is a composite of lead which is formed as AGM and VRLA, more information on these construction processes can be found below
- Imed mini PC4 battery replacement
The battery pack that you receive from us will be almost fully charged, but you should still charge them before first use, this will not be necessary only if being fitted in something that has its own built in charger that is always connected to the mains like an alarm system which will do the job for you, just charge them until your charger LED lights indicate that they are ready, it will probably not take very long, do not just install and use without this initial charge, unless the situation is as stated above, doing so can shorten expected life span, it's well worth doing
If being used in a portable device it may well take a number of charges and alternating use in your equipment for the battery to condition and be able to take a full capacity charge, this is quite normal, if being used in a portable device then you should make sure that after every use that you put the batteries back on charge, letting them sit in a partially discharged state is not wise, we have heard of people trying to extend battery life by running them all the way down, do not attempt this with this kind of technology, fully discharging your new batteries will only reduce the overall life span and they will need changing earlier, this will cost you money in the long run, if there are extended periods where you are not using the batteries you should remember to recharge every four weeks and never put them away discharged, even partially, do not leave on the charger for more than 24-hours at a time
This type of battery is valve regulated lead acid, VRLA for short, they still have acid but its trapped between a glass matting, this is why they are also called AGM or absorbed glass mat, you will never to need to top them up with fluid, if fact you cannot as they are sealed, they are not-hazardous and can safely be used indoors or in portable devices with no fear of leakage
We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery, take note of the dimensions and anything written on the side of them, we have included the size below so you can double check, this 6-volt 3.2-amp hour uses a very high content of lead or PB in its manufacture, this is very easy to recycle so it can further be used in another product, more information on this process can be found on our recycle page link at the foot of this one
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = sealed lead, AGM, VRLA
This offer is for a total of 1 ready to install batteries for the Imed mini PC4 here is the dimensions of a single battery
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
