Teledyne Big Beam ET6S5 6-volt 7ah battery replacement AGM VRLA
Replacement Teledyne Big Beam ET6S5 6v 7ah battery pack, rechargeable sealed lead acid, safe non-spillable valve regulated VRLA batteries with advanced AGM technology at low competitive cost
On this page you will find we have listed all of the required data to support your consideration of a purchase of a new battery for the Teledyne Big Beam ET6S5 compatible battery pack, they are 7amp hour and 6-volt batteries, deep cycle capable and rechargeable as well as safe to handled and used indoors, combined with safety as these AGM and VRLA batteries are not-hazardous and non spillable, more information on these chemistries can be found further down the page
- Teledyne Big Beam ET6S5 battery replacement
The batteries that you obtain from us will be almost fully charged, but you still need to charge them fully before first use, it should not take that long to finish the charge, just until the charger lights indicates its ready, if really in doubt overnight will be more than enough but it's doubtful you would need to leave it that long, you may well be impatient enough just to fit and use the equipment without charging but it's well worth waiting until its fully charged and will help extend overall life expectancy
It may not be apparent but it will take a few charges and associated use in your device before the battery is capable of receiving a full capacity charge, this is quite normal, when you have used your device then put the batteries back on charge, you do not want to allow them to sit in a partially discharged state, do not attempt to discharge the batteries fully, this can reduce life span quite drastically so cost you money in the long run, if there are extended periods where you are not using the batteries you should remember to recharge every four weeks and do not put them away discharged, even partially, do not leave on the charger for more than 24-hours at a time
These 6-volt batteries are valve regulated and AGM or absorbed glass mat, no need for any liquid as the acid is held within the glass mat, this means they will not spill and not-hazardous so safe for use around the home or portable devices, they are deep cycle which would be required in this sort of application
Ensure that you order the right battery by carefully checking the code on your old one and comparing it to the information here, a lot of them are very similar so it can be easy to make a mistake, if in doubt check the batteries themselves, the dimensions and anything written on the side of them, we have included the physical sizes of the batteries so you can double check, these batteries are made mainly of lead which is easy to be recycled, more information about recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 7Ah @20Hr
Chemistry = absorbed glass mat, AGM, VRLA
This set contains 1 ready to install batteries for the Teledyne Big Beam ET6S5 the overall size of each battery is
Length = 151mm or 5.94-inches
Width = 34mm 1.33-inches
Height = 94mm or 3.7-inches
Battery layout - from chart below = 1
