APC Back-UPS-325, BE325-UK replacement battery set sealed lead.
Replacement APC Back-UPS-325, BE325-UK battery set, valve regulated safe non-spillable rechargeable batteries they are AGM and VRLA at low competitive price direct from warehouse.
The following information is to help you make a purchase for replacement batteries for the APC Back-UPS-325, BE325-UK. the electricity supplied from the mains is passed through the system and batteries to offer a clean supply at the other end, they are 12v cells. comes with a 12v battery which is what the offer on this page is these are of course rechargeable. they are non spillable, safe, and not-hazardous AGM and VRLA which are capable of deep cycling which is vital in this sort of installation where they are constantly being used 24-hours a day.
- APC Back UPS 325 battery
- BE325-UK battery replacement
The task of installing the batteries is not a difficult one, you should refer to your manual for the full method, once you have them in the system it will fully charge them. even though they will come out to you almost charged it will still need to complete this task, of course, while this charge going on your UPS will not be able to offer the full runtime protection until its finished this, while it's not always convenient it would be best to run without load to start so it can fully reset itself to the new battery energy level.
You could certainly expect these batteries to last somewhere between two to five years in this UPS, this is not a set rule though and a lot will depend on how they are used, good ventilation is always important, if it's in an office do not use it as a bookshelf. keeping the load low will also help extend the life span. in an ideal world keep it below 40%, they are so often run to the edge of their capabilities, while they may be more than able to, it will be at the expense of the life span.
The battery cells are constructed from absorbed glass mat technology or AGM, they are also valve regulated sealed lead acid or VRLA, this is the recommended type of battery for this installation, they will not leak if mounted on the side so safe to be used in a UPS tower or rack-mountable configuration with fear of spillage in mission-critical applications like a hospital or busy data centre as well as the home office.
The information we have provided on this page is a guide, you should carefully check the code on your UPS before ordering as many are very similar, the batteries are recyclable and environmentally friendly, more information about recycling can be found on a link at the foot of this page.
Voltage = 12v
Capacity = 3.2Ah @20Hr
Chemistry = VRLA, AGM
Hot swap capable
This offer is for a sealed lead battery for the APC Back-UPS-325, BE325-UK the overall dimensions is:
Length = 134mm
Width = 67mm
Height = 61mm
