Piller Technology 4 Wheeler 410 batteries disabled VAT relief mobility
Replacement Piller Technology 4 Wheeler 410 rechargeable 12-volt battery pack, valve regulated VRLA sealed AGM, safe non-spillable mobility batteries with disabled VAT relief direct from warehouse at low price
Below you will find we have listed all of the information on this page to help assist you in the renewal of a set of mobility batteries for your Piller Technology 4 Wheeler 410, the energy required for use is stored in deep cycle batteries, they are 34-amp hour batteries, it uses 2 x 12-volt batteries, they are replacements for them, they are as would be required rechargeable type of battery, deep cycle capable which would be needed in this kind of application and not-hazardous and will not spill so therefore safe to use indoors, AGM and VRLA cells, more information about these chemistries will be found below
- Piller Technology 4 Wheeler 410 battery replacement
Even though the batteries you receive from us will be almost fully charged you should still complete a full charge before first use, your charger will indicate to you when it has completed a charge, the light will generally change to indicate this, you may well just want to fit them and use the equipment, but do not miss this first step, it's worth waiting until the first charge has completed and it might contribute to over life span
You may not notice it but it will probably take a few charges and use in your equipment before you are able to receive a full capacity charge in your batteries, this is quite a normal part of the conditioning process, as soon as you after each use put them back on charge, do not allow them to sit in a discharged state, do not attempt to discharge the batteries fully, this can reduce life span quite drastically so cost you money in the long run, it is important to keep a charge in the batteries for long life, so if there is any period of time where they are not being used then charge before hand and top this up every four weeks but do not leave on a charger for more than 24-hours
These batteries are deep cycle capable, which is essential in this type of application, the VRLA and AGM cells will not leak and not-hazardous so suitable for travelling, there is not maintenance required, except of course charging which we have covered on this page, both VRLA and AGM
You should confirm the code on your mobility equipment carefully, there are many that are very similar so you order the right battery set, if in doubt look at you old batteries, check the dimensions and take note of anything written on the side of them, we have also included the physical dimensions of the battery to make certain, the batteries themselves have a very high lead content so they are recyclable, more detailed information about recycling lead batteries can be found on a link at the foot of this page
Voltage = 12-volts
Capacity = 34Ah @20Hr
Chemistry = VRLA, AGM
In this pack there is 2 recyclable lead batteries for the Piller Technology 4 Wheeler 410 the physical dimensions of each battery is
Length = 195mm or 7.67-inches
Width = 130mm 5.11-inches
Height = 156mm or 6.14-inches
Battery layout - from chart below = 1

As an easy upgrade path we are able to offer this mobility battery size as a 38ah version, it will slip straight into the same cavity but offer you a more miles per charge, the link to this will be a little bit further below