Bruno PWC 2210 battery replacement X2 disabled VAT relief mobility
Replacement Bruno PWC 2210 mobility battery pack, rechargeable sealed lead non-hazardous 12-volt batteries that will not leak, disabled VAT relief available, VRLA, AGM at low competitive prices
Below you will find we have listed all of the information on this page to help assist you in the renewal of a set of mobility batteries for your Bruno PWC 2210, the power supply uses these storage batteries, they are 34-amp hour batteries, it uses 2 x 12-volt batteries, they are replacements for them which are as would be needed in such an application rechargeable, they are of course non-spillable and not-hazardous so safe to use indoors, they have a AGM and VRLA type of cell which is what should be fitted in this type of electric vehicle, more information on the chemistry will be found below
- Bruno PWC 2210 battery replacement
When you receive your order from us you will note that the batteries will be almost fully charged, but it is important to fully charge them before first use, the time of the first charge will be dependent on the charger, just leave it on until its finished, do not just install and go without this initial charge, doing so can shorten expected life span, it's well worth doing
It may be apparent that it will take a few charges and associated use in your electric vehicle before the battery is capable of receiving a full capacity charge, this is quite normal, allowing your new batteries to sit without charge is not a good idea, as soon as you have finished using it put it back on charge, do not attempt to discharge the batteries fully, this can reduce life span quite drastically so cost you money in the long run, if it turns out there are periods where the equipment is not being used on a regular basis then ensure the batteries are fully charged before any period of downtime and then topped up every four weeks but do not leave on the charger for more than 24-hours
These 12-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or on the road or pavement without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not-hazardous so safe for use in travel including aeroplanes but you should check with your airline at time of booking
We have provided the information here only as a guide, you need to check the code on your mobility device carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the dimensions so you can make sure you are ordering the correct pack, looking at your old batteries, taking note of the dimensions and anything that may be printed on the side is probably the wisest thing to do, these batteries are recyclable the main component is lead which can easily be recycled, more information on this can be found at the bottom on this page on our recycling link
Voltage = 12-volts
Capacity = 34Ah @20Hr
Chemistry = sealed lead acid, VRLA, AGM
This offer is for a set of 2 quality batteries for the Bruno PWC 2210 the overall dimensions of each battery are
Length = 195mm or 7.67-inches
Width = 130mm 5.11-inches
Height = 156mm or 6.14-inches
Battery layout - from chart below = 1
If you prefer we can offer this mobility battery in a 38Ah format, it's the same dimensions and will slip straight in, a very easy upgrade that will offer more miles per charge, the link to it will be just a little bit further down the page
