PBQ PBQ2.3-12 replacement 12v battery sealed AGM.
Replacement PBQ PBQ2.3-12 sealed lead battery pack, rechargeable system valve regulated 12v batteries, VRLA and AGM, they will not spill, safe to be mounted on the side often seen in portable devices, alarm systems, hoists and security lighting offered at a low competitive cost.
Please find below the information that we have compiled to help you make an informed decision on the purchase of a new replacement compatible battery for the PBQ2.3-12, they can store 2.1ah of energy in the 12v cells and are seen in many devices from portable medical, patient lift equipment to security alarm systems and are capable of deep cycling, these are of course rechargeable, they are non-spillable, safe and not-hazardous so safe to be handled, stored and used indoors, the cell structure is a composite of lead formed as AGM and VRLA.
When your order is delivered the batteries will be almost fully charged, but regardless of this, you should still complete a charge them before first use, If you are fitting this battery as a backup in something that is always connected to the mains, such as a home or commercial alarm system then you can skip this step. you do not need to leave it on for hours on end, it will probably not take very long at all depending on the charger. just until it has finished, do not just use without this initial charge, unless as stated above, doing so can shorten the expected life span, it's well worth doing.
You probably will not even notice it but it will take a few charges and use in your equipment before you can receive a full capacity charge in your batteries, this is quite a normal part of the conditioning process, put the batteries back on charge after use, you do not want to allow them to sit in a partially discharged state, we have heard of people trying to extend battery life by running them down. fully discharging your new batteries will only reduce the overall life span and they will need changing earlier, this will cost you money in the long run, it is important to keep a charge in the batteries for a long life, so if there is any time where they are not being used then charge beforehand and top this up every four weeks but do not leave on a charger for more than 24-hours.
The battery type is AGM which is short for absorbed glass mat construction, they are also valve-regulated. This means they can be used around the home or in portable devices without the fear of any leakage, with deep cycle properties that this type of installation would require, they will require no maintenance throughout their entire life span and are not hazardous.
We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery. take note of the dimensions and anything written on the side of them, we have included the size below so you can double-check, These 12-volt 2.1ah batteries are made mainly of lead which is easy to recycle, more information about recycling can be found at the foot of this page.
Voltage = 12v
Capacity = 2.1Ah @20Hr
Chemistry = sealed lead acid, VRLA, AGM.
We are offering a total of one quality battery for the PBQ 2.3-12 the overall size of each battery is:
Length = 178mm or 7-inches
Width = 35mm 1.37-inches
Height = 60mm or 2.36-inches.
