Baxter 6 Floguard infusion pump battery replacement 3.2ah 12v.
Replacement Baxter 6 Floguard infusion pump battery pack, rechargeable valve regulated sealed lead 12-volt 3.2ah batteries, will not spill sealed at low prices.
The offer on this page as mentioned is for a replacement battery pack for the Baxter 6 Floguard infusion pump they are valve regulated sealed 12-volt 3.2-amp hour, these are non-spillable VRLA and AGM, they can be used in portable devices without fear of spillage.
- Baxter 6 Floguard infusion pump battery
This AGM type battery does not need any maintenance, the acid is contained within a glass mat so will not leak out if laid on its side, it is not-hazardous so can be used indoors and indeed often used in portable devices.
Although we have supplied the information on the page in good faith there are many reasons why this compatible battery could be incorrect ordered, the physical dimensions are listed below.
Voltage = 12-volts
Capacity = 3.2Ah @ 20Hr
Chemistry = AGM, VRLA.
This set contains one batteries for use in the Baxter 6 Floguard infusion pump we have listed the size of each battery below:
Length = 134mm or 5.27-inches
Width = 67mm or 2.63-inches
Height = 61mm or 2.4-inches
Standard push fit flat terminals - 4.75mm or 0.187 inch.
This battery will come out to you almost fully charged, upon receipt fully charge it before using and again after every use, it is important that you do not try to run down the cells, if you are not using for several weeks at a time then a top up charge every four weeks will be required to keep the cells in good order, by not keeping your new battery fully charged you are risking a shorter life which will cost you money in the long run.
