PPG Biomedical systems monitor battery replacement 3.2ah 12v.
Replacement PPG Biomedical systems monitor battery pack, rechargeable valve regulated sealed lead 12-volt 3.2ah batteries, will not spill sealed at low prices.

This page is dedicated to offering detailed information for your consideration for a replacement battery pack for a PPG Biomedical systems monitor which is 12-volts with a 3.2ah capacity sealed lead, as they are AGM and VRLA they are safe to use indoors and will not leak, likewise suitable for portable devices, they are of course rechargeable.

• PPG Biomedical systems monitor battery

These type of cell is AGM or absorbed glass mat, this means that they do not require any maintenance, the acid is safely constrained within a glass mat between the cells and it will not leak so it's ok to mount on its side, it will not spill, they are also valve regulated for safety.

The details of this compatible battery pack are offered as a guide, you should check the codes on your old battery before ordering a replacement.

Voltage = 12-volts
Capacity = 3.2Ah @ 20Hr
Chemistry = AGM, VRLA.

There is a total of one quality batteries for the PPG Biomedical systems monitor the physical size of the individual batteries are as follows
Length = 134mm or 5.27-inches
Width = 67mm or 2.63-inches
Height = 61mm or 2.4-inches
Standard push fit flat terminals - 4.75mm or 0.187 inch.

This battery will come out to you almost fully charged, upon receipt fully charge it before using and again after every use, it is important that you do not try to run down the cells, if you are not using for several weeks at a time then a top up charge every four weeks will be required to keep the cells in good order, keeping your new sealed battery fully charged will help it last longer.