Access MNC8451P SLA665 SLA672 6-volt battery replacement 7ah AGM
Replacement Access MNC8451P SLA665 SLA672 7ah battery pack, valve regulated sealed lead acid rechargeable 6-volt absorbed glass mat batteries, offered at low prices direct from warehouse
Below you will find we have entered details for the battery to replace the Access MNC8451P SLA665 SLA672 compatible battery pack, they are 7amp hour and 6-volt batteries, deep cycle capabilities as would be needed in this type of use, they are safe to be handled and to use indoors, also recyclable the main component of the cells is lead so they are very easily recycled and environmentally friendly, more information can be found on our recycle page
- Access MNC8451P SLA665 SLA672 battery replacement
After placing your order and upon receipt of your new battery pack you may will note that they have a good charge in them, but regardless of this you will still need to charge them fully before using for the first time, it should not take that long to finish the charge, just until the charger lights indicates its ready, if really in doubt overnight will be more than enough but it's doubtful you would need to leave it that long, do not just fit them and roll without this initial charge, it will help to extend the battery life overall
You probably will not notice but it will take up to ten charges and associated use in your device before the batteries are capable of taking a few capacity charge, this is normal, after you have used your equipment you should get a charge back into it as soon as you are able, do not leave it sitting around in a partially discharged state for any longer than absolutely necessary, going out of your way to fully discharge the batteries will reduce their life span, so do not do it, it is important to keep a charge in the batteries for long life, so if there is any period of time where they are not being used then charge before hand and top this up every four weeks but do not leave on a charger for more than 24-hours
These batteries are deep cycle capable, which is essential in this type of application, the VRLA and AGM cells will not leak and not-hazardous so suitable for portable equipment, there is no maintenance required, except of course charging which we have covered on earlier on this page, both VRLA and AGM
So many codes on the batteries are almost the same, you should check them carefully before ordering to make sure you get the right one, if in doubt, look at your old batteries, take note of the dimensions and all that is written on the side, it will always be the best information to have, we have also included on the page the dimensions so that you can confirm before ordering, these batteries are made mainly of lead which is easy to transform so therefore environmentally friendly and recyclable, more information regarding recycling will be found at a link at the foot of this page
Voltage = 6-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, sealed lead, VRLA
There is 1 quality lead acid batteries for the Access MNC8451P SLA665 SLA672 the physical dimensions of each battery is
Length = 151mm or 5.94-inches
Width = 34mm 1.33-inches
Height = 94mm or 3.7-inches
Battery layout - from chart below = 1
