Brooks Equipment BAT665 BAT67 6-volt 7ah battery replacement AGM
Replacement Brooks Equipment BAT665 BAT67 rechargeable 6-volt 7ah battery pack, valve regulated VRLA sealed AGM, safe non-spillable batteries direct from warehouse at low price
Here you will find we have offered on the page the relevant information to help you consider the decision of purchasing batteries to replace the Brooks Equipment BAT665 BAT67 compatible battery pack, they are 7amp hour and 6-volt batteries, they are safe to handled and to use indoors, suitable for deep cycling as well of course as rechargeable they are made for this kind of application, they are the required VRLA with AGM technology (more information about the qualities of the chemistry of them will be found below) they are recyclable and very environmentally friendly, see our recycle page for details
- Brooks Equipment BAT665 BAT67 battery replacement
Even though the batteries you receive from us will be almost fully charged you should still need to complete a full charge before first use, this would not be the case if it's going in something with its own power supply, for example an alarm system as this will do the job for you, the period of this initial charge before use need only be until the charger states they are ready, it probably will not take long, do not just fit them and roll without this initial charge, it will help to extend the battery life overall
Most users will not even notice but it will take a number of charges and associated use in your equipment before they are capable of accepting a full capacity charge, this is quite normal and part of the conditioning process, once you have used your equipment put the batteries back on charge, do not let them sit in a partially discharged state for any longer than absolutely necessary, do not attempt to deliberately discharge the batteries, it will only do them harm and will reduce the life span, they may be protracted periods where the batteries are not being used, if this is the case ensure they are fully charged first, then top up every four weeks but do not leave on a charger for more than four weeks
These batteries are deep cycle capable, which is essential in this type of application, the VRLA and AGM cells will not leak and not-hazardous so suitable for portable equipment, there is no maintenance required, except of course charging which we have covered on earlier on this page, both VRLA and AGM
You should confirm the code on your battery carefully, there are many that are very similar, if in doubt look at you old batteries, check the dimensions and take note of anything written on the side of them, we have also included the physical dimensions of the battery to make certain, the batteries are as you would expect recyclable, more detailed information on recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, sealed lead, VRLA
There are a total of 1 rechargeable batteries as used in the Brooks Equipment BAT665 BAT67 we have mentioned the size below of each battery for your convenience
Length = 151mm or 5.94-inches
Width = 34mm 1.33-inches
Height = 94mm or 3.7-inches
Battery layout - from chart below = 1
