ML512V ML5S12V 6v 7ah battery replacement sealed lead AGM VRLA
Replacement ML512V ML5S12V rechargeable battery pack, valve regulated sealed lead 6-volt 7ah batteries with VRLA and AGM technology, at low competitive price direct from warehouse
Below you will find we have listed the relevant information to help you consider the decision on the purchase of a new batteries to replace the ML512V ML5S12V compatible deep cycle batteries which are 7amp hour and 6-volt batteries, use they are capable of deep cycling and rechargeable, two very necessary requirements in this type of installation, also they are non-spillable and not-hazardous so safe to be handled and for use indoors, the cells are AGM and VRLA of which more information can be found further down the page
- ML512V ML5S12V battery replacement
When place your order you will note that the batteries will be almost fully charged when received, but it is still important to fully charge them before first use, this would not be the case if it's going in something with its own power supply, for example an alarm system as this will do the job for you, the period of this initial charge before use need only be until the charger states they are ready, it probably will not take long, do not just fit them and roll without this initial charge, it will help to extend the battery life overall
it may well take a number of full charges and alternating use in your equipment for the battery to condition and be able to take a full capacity charge, this is quite normal, make sure that you charge your new batteries after each and every use, they are capable of many charges but this will reduce if you let run them down in-between, do not attempt to deliberately discharge the batteries, it will only do them harm and will reduce the life span, If there are extended periods where the batteries are not being used then ensure they are fully charged beforehand then recharged every four weeks but you should not leave on the charger for more than 24-hours
These 6-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not-hazardous so safe
We offer the information on this page purely as a guide only, if you carefully check the code on your old battery then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old batteries, take note of the dimensions and anything written on the side of them, we have included the dimensions of these batteries so you can double check, the batteries are as you would expect recyclable, more detailed information on recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 7Ah @20Hr
Chemistry = sealed lead acid, VRLA, AGM
In this pack there is 1 batteries for use in the ML512V ML5S12V the overall size of the batteries are
Length = 151mm or 5.94-inches
Width = 34mm 1.33-inches
Height = 94mm or 3.7-inches
Battery layout - from chart below = 1
