Eaton EB028SP EB010SP UPS battery replacement.
Twin-pack compatible battery replacement set for Eaton EB028SP and EB010SP UPS, compatible battery replacement pair to bring back proper runtime.
When the warning beeps start coming sooner, the self-test throws an error, or the runtime drops, it’s nearly always the cells inside reaching the end of their working life. Because these two models use the same two battery setup, this page is offering replacement batteries for either the Eaton EB028SP or EB010SP.
- Eaton EB028SP UPS battery replacement
- Eaton EB010SP UPS battery replacement
The technology is sealed lead-acid (VRLA/AGM), so there’s no topping up, no maintenance routine, and no mess. They’re spill-resistant and suited to enclosed UPS bays where access is limited, while still delivering the high burst current a UPS demands during changeover and brief high-load moments.
To stretch service life, keep the UPS away from heat sources and give it decent airflow. After an outage, let it recharge fully rather than leaving it partially flat, and avoid running the UPS permanently near its limit, extra load creates extra heat, and heat is what wears UPS batteries out fastest.
Chemistry of battery: VRLA, AGM, Pb, and sealed lead.
The voltage of the battery: 12v.
The capacity of the battery: 8.8Ah @20-hr, amp-hour.
There are a total of two batteries in this set for the Eaton EB028SP and EB010SP. The size of each is as follows:
Length = 151mm
Width = 65mm
Height = 94mm.
