7200 infusion pump battery sealed lead 3.2-amp VRLA non spill AGM
Replacement 7200 infusion pump rechargeable 12-volt batteries, valve regulated sealed lead acid non-spillable safe 3.2ah battery pack, absorbed glass mat AGM cells low competitive price

Below you find we have compiled detailed information and physical specifications of a replacement battery pack for a 7200 infusion pump which run at 12-volts and have a energy capacity of 3.2-amp hour as they will not leak or need any maintenance they can be used in portable equipment and found in things for childrens toys to essential portable medical equipment

• 7200 infusion pump battery

AGM batteries are very handy for portable devices, they will not leak, not-hazardous so can be used inside, they can be safely mounted on the side, they do not need topping up with fluid, they need no maintenance, they are valve regulated or VRLA

If you have already checked your old battery serial codes then do so, this is only a guide, collated data from available resources, the physical dimensions of this compatible one are listed here on the page

Voltage = 12-volts
Capacity = 3.2Ah @ 20Hr
Chemistry = AGM, VRLA

This offer is for a rechargeable and recyclable battery for the 7200 infusion pump the dimensions of the individual battery pack are as follows
Length = 134mm or 5.27-inches
Width = 67mm or 2.63-inches
Height = 61mm or 2.4-inches
Flat spade terminals 4.75mm

Your new 12-volt battery will come out to you pretty much fully charged, but unless it's going in something with its own built in always on mains connected charging circuit, like for example a alarms system then you should still charge when you receive it and before first use, and for that matter after every use, do not try to discharge it, and if not being used charge every 4-weeks, by not keeping your new battery fully charged you are risking a shorter life which will cost you money in the long run