- EA613 battery replacement
- Elk 0613 battery replacement
After you have unpacked your new battery order from us you will note that they will have a good charge in them, regardless of this you should still complete a full charge before first use, this will not be necessary only if being fitted in something that is always connected to the mains like an alarm system which will do the job for you, the charge time will depend on your charger, just leave it on until it indicates its finished, this first step is important so do not ignore it, unless as otherwise stated above, do not use without this initial charge, doing so can shorten expected life span
Most users will not even notice but it will take a number of charges and associated use in your equipment before they are capable of accepting a full capacity charge, this is quite normal and part of the conditioning process, if being used in a portable piece of equipment then as soon as you after each use put them back on charge, do not allow them to sit in a discharged state, discharging the batteries fully will only reduce their life expectancy, you cannot kick start this kind of battery in that way, it will do them no good and will cost you money in the long run, they may be protracted periods where the batteries are not being used, if this is the case ensure they are fully charged first, then top up every four weeks but do not leave on a charger for more than 24-hours
The battery type that we are offering her is VRLA and AGM, they need no maintenance, no topping up of fluids, they are sealed lead acid and valve regulated with AGM technology, they are not-hazardous and safe to use around the home or in portable devices well as travellingSo many codes on batteries are almost the same, you should carefully check them before ordering to ensure you are getting the right pack, if in doubt then look at your old one, take a note of the dimensions and anything that is written on the side, this will always be the best information to have, we have also included on the page the dimensions so you can confirm before ordering, these 6-volt 1.2ah batteries are recyclable, the overlaying main content is lead which is easily transformed into another product, more information about recycling can be found on our recycling page, link to which is at the foot of this page
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = VRLA, AGM
We are offering 1 lead acid batteries for the BR01C7BD01, BEL060013, EA613, Elk 0613 the overall size of each battery is
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1
