CAS Medical 820 neonatal BP Monitor 6-volt 1.2ah battery replacement
Replacement CAS Medical 820 neonatal BP Monitor battery pack, valve regulated sealed lead acid rechargeable 6-volt 1.2ah absorbed glass mat batteries, offered at low prices direct from warehouse

Please find below on this page the relevant details to help you consider the decision of purchasing a new compatible replacement battery for your CAS Medical 820 neonatal BP Monitor, they are 6-volt with 1.2ah of energy storage and capable of deep cycling, these are of course as would be needed rechargeable, they are non spillable, safe and not-hazardous so safe to be handled, stored and used indoors, the cell structure is a composite of lead formed as AGM and VRLA

• CAS Medical 820 neonatal BP Monitor battery replacement

After you have unpacked your new battery order from us you will note that they will have a good charge in them, regardless of this you should still complete a full charge before first use, this will not be necessary only if being fitted in something that is always connected to the mains like an alarm system which will do the job for you, the time of the first charge will be dependent on the charger, just leave it on until its finished, it will probably not take very long, do not miss out this important first step, it will help set them up and possibly extend the possible overall life expectancy of them

You probably will not notice but it will take up to ten charges and associated use in your device before the batteries are capable of taking a few capacity charge, this is normal, allowing your new batteries to sit without charge is not a good idea if using them in a portable device, as soon as you have finished using it put it back on charge, never go out of your way to deliberately discharge fully, this will only reduce overall life span, if for any unforeseen reason they is an extended period where you are not using the batteries make sure they are fully charged first, then recharge every four weeks but do not leave on the charger for more than 24-hours

The battery type that we are offering her is VRLA and AGM, they need no maintenance, no topping up of fluids, they are sealed lead acid and valve regulated with AGM technology, they are not-hazardous and safe to use around the home or in portable devices well as travelling

We have provided the information here only as a guide, you need to check the code carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the relevant dimensions so you can make sure you are ordering the correct one, looking at your old power pack and taking note of the dimensions and anything that may be printed on the side is probably the wisest thing to do, this 6-volt 1.2ah battery is as you would expect recyclable, more detailed information on recycling can be found at the foot of this page

Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = valve regulated lead acid, VRLA, AGM

In this pack there are a total of 1 ready to install batteries for the CAS Medical 820 neonatal BP Monitor the dimensions of the individual battery pack are as follows
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1