Dyna-Cell-WP1.26 battery replacement 6-volt 1.2ah sealed AGM
Replacement Dyna-Cell-WP1.26 battery pack, rechargeable 6v 1.2ah sealed lead acid, safe non-spillable valve regulated VRLA batteries with advanced AGM technology at low competitive cost
Please find below on this page the relevant details to help you consider the decision of purchasing a new compatible replacement battery for your Dyna-Cell-WP1.26, which has a energy storage capacity of 1.2-amp hours, the cells are 6-volt and capable of deep cycling, they are as would be needed rechargeable and not-hazardous and will not spill so therefore safe to be handled and to use indoors or in portable equipment, AGM and VRLA cells, more information about these chemistries will be found below
The batteries will be delivered with a very good charge in them, but even so you should still charge before using for the first time, however if it's a battery backup for something that's always connected to the mains like a monitor or maybe a alarm system then you do not need to charge it first as the system will do that for you, the charge time will depend on your charger, just leave it on until it indicates its finished, do not just fit them and roll without this initial charge, it will help to extend the battery life overall
If you are a normal user then you will probably not even notice it but it can take up to ten charges and associated use in your device before its capable of accepting a full capacity charge, this is all part of the conditioning process and quite normal, after you have used your more portable equipment you should get a charge back into it as soon as you are able, do not leave it sitting around in a partially discharged state for any longer than absolutely necessary, discharging the batteries fully will only reduce their life expectancy, you cannot kick start this kind of battery in that way, it will do them no good and will cost you money in the long run, if there are extended periods where you are not using the batteries you should remember to recharge every four weeks and never put them away discharged, even partially, do not leave on the charger for more than 24-hours at a time
These 6-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or in portable equipment without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not hazardous
So many codes on batteries are almost the same, you should carefully check them before ordering to ensure you are getting the right pack, if in doubt then look at your old one, take a note of the dimensions and anything that is written on the side, this will always be the best information to have, we have also included on the page the dimensions so you can confirm before ordering, this 6-volt 1.2ah battery is as you would expect recyclable, more detailed information on recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = absorbed glass mat, AGM, VRLA
The size of this replacement Dyna-Cell-WP1.26 is
Length = 97mm / 3.81-inches
Width = 24mm / 0.94-inches
Height = 51.5mm / 2.02-inches
Battery layout - from chart below = 1
