Hitachi HP126 6-volt battery replacement sealed lead AGM VRLA
Replacement Hitachi HP126 non spill 6-volt 1.2-amp hour battery pack, safe can be used in portable devices, valve regulated sealed lead VRLA AGM rechargeable batteries at low cost
We have tried to list here and below on this page, all the relevant information to help you make the decision of purchasing a new replacement compatible battery for your Hitachi HP126, which has a energy storage capacity of 1.2-amp hours, the cells are 6-volt and capable of deep cycling, which as you would expect and require, rechargeable, they're sealed and will not spill any liquids, so safe to handle and use indoors, they are AGM and VRLA offering a long life, more information on the chemistry of them will be found below
- Hitachi HP126 battery replacement
The batteries that you obtain from us will be almost fully charged, but you should still charge them fully before first use, however if it's a battery backup for something that's always connected to the mains like a monitor or maybe a alarm system then you do not need to charge it first as the system will do that for you, your charger will indicate to you when it has completed a charge, it will probably not take very long depending on the charger, the light will generally change to indicate its ready, do not miss out this important first step, it will help set them up and possibly extend the possible overall life expectancy of them
If you are a normal user then you will probably not even notice it but it can take up to ten charges and associated use in your device before its capable of accepting a full capacity charge, this is all part of the conditioning process and quite normal, allowing your new batteries to sit without charge is not a good idea if using them in a portable device, as soon as you have finished using it put it back on charge, do not attempt to deliberately discharge the batteries, it will not rejuvenate them, it will only do them harm and will reduce the life span, these batteries need to be kept charged, so if there is any reason where they are not be used then ensure they are charged beforehand and then every 4-weeks, but do not leave on a charger for more than 24-hours
These 6-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or in portable equipment without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not hazardous
The information we have provided on this page is a guide, you should carefully check before ordering as many are very similar, if still in doubt you can look at your old battery, take a note of the dimensions and anything that may be written on the side of them, this will always be the best way, we have also included the physical dimensions on this page so you can confirm, the batteries themselves are 6-volt 1.2ah and have a very high lead content so they are recyclable, more detailed information about recycling lead batteries can be found on a link at the foot of this page
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = sealed lead acid, VRLA, AGM
You will find a total of 1 quality lead acid batteries for the Hitachi HP126 the physical dimensions are as follows
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1
