IRD Mechanalysis 885 replacement 6-volt battery sealed lead AGM
Replacement IRD Mechanalysis 885 rechargeable batteries, 6-volt 1.2ah valve regulated sealed lead acid non-spillable safe battery pack, absorbed glass mat AGM cells, low competitive price
Here you will find we have offered on the page the relevant information to help you consider the decision of purchasing a new compatible replacement battery for your IRD Mechanalysis 885, they can store 1.2-amp hours of energy in the 6-volt cells and capable of deep cycling, being AGM and VRLA they are rechargeable, they are safe to be handled and to use indoors or in portable devices, also recyclable the main component of the cells is lead so they are very easily recycled and environmentally friendly, more information can be found on our recycle page
- IRD Mechanalysis 885 battery replacement
The batteries that you obtain from us will be almost fully charged, but you should still charge them fully before first use, however if it's a battery backup for something that's always connected to the mains like a monitor or maybe a alarm system then you do not need to charge it first as the system will do that for you, it shouldn't take long, just until the charger lights indicates its ready, if really in doubt overnight will be more than enough but it's doubtful you would need to leave it on the charger that long, you may well be impatient and use the equipment without charging but it's worth waiting until its fully charged and will help extend overall life expectancy
While is not something that most will even notice but it will take a number of charges and corresponding use in the device before a full capacity charge is reached, this is a normal part of the conditioning process, after you have used your more portable equipment you should get a charge back into it as soon as you are able, do not leave it sitting around in a partially discharged state for any longer than absolutely necessary, do not try to fully discharge the batteries, it will not rejuvenate them, it will reduce the lifespan and cost you money in the long run, it is important to keep a charge in the batteries for long life, so if there is any period of time where they are not being used then charge before hand and top this up every four weeks but do not leave on a charger for more than 24-hours
These are 6-volt valve regulated sealed lead acid batteries and will not leak they are both AGM and VRLA, of course they are the required deep cycle kind and they are not-hazardous so safe for use in portable equipment, medical and indoors
You should confirm the code on your old battery carefully, there are many that are very similar so you want to order the correct one, check the dimensions and take note of anything written on the side of them, we have also included the physical dimensions so you can make certain, these 6-volt 1.2ah batteries are made mainly of lead which is easy to be recycled, more information about recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = VRLA, AGM
This set contains 1 rechargeable batteries to replace the IRD Mechanalysis 885 the overall size of the batteries are
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1
