Lintronics NP126 6-volt battery replacement sealed AGM VRLA 1.2ah
Replacement Lintronics NP126 battery pack, rechargeable 6-volt valve regulated sealed lead acid mobility batteries, 1.2ah non-spillable
Here you will find we have offered on the page the relevant information to help you consider the decision of purchasing a new compatible replacement battery for your Lintronics NP126, which has a energy storage capacity of 1.2-amp hours, the cells are 6-volt and capable of deep cycling, being AGM and VRLA they are rechargeable, they are safe to be handled and to use indoors or in portable devices, also recyclable the main component of the cells is lead so they are very easily recycled and environmentally friendly, more information can be found on our recycle page
- Lintronics NP126 battery replacement
The batteries you receive from us will be almost fully charged, but you should still charge them before first use, this will not be necessary only if being fitted in something that is always connected to the mains like an alarm system which will do the job for you, while you only need to fulfil the charge until the charger indicates that its ready, it probably will not take long and it is very important so not a step you should overlook, you may well just want to fit them and use the equipment, but do not miss this first step if needed, it's worth waiting until the first charge has completed and it may well contribute to over life span
it may well take a number of charges and alternating use in your equipment for the battery to condition and be able to take a full capacity charge, this is quite normal, each time you have used your battery in a more portable device then you should put it back on charge as soon as you can, do not leave it sitting in a semi discharged state for any longer than necessary, we have heard of people trying to extend battery life by running them down, fully discharging your new batteries will only reduce the overall life span and they will need changing earlier, this will cost you money in the long run, if there are extended periods where you are not using the batteries you should remember to recharge every four weeks and never put them away discharged, even partially, do not leave on the charger for more than 24-hours at a time
These are 6-volt valve regulated sealed lead acid batteries and will not leak they are both AGM and VRLA, of course they are the required deep cycle kind and they are not-hazardous so safe for use in portable equipment, medical and indoors
We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery, take note of the dimensions and anything written on the side of them, we have included the size below so you can double check, as these 6-volt 1.2ah batteries are made of lead they are recyclable and environmentally friendly, more information about recycling can be found on a link at the foot of this page
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = sealed lead acid, VRLA, AGM
There are 1 lead acid batteries for the Lintronics NP126 the overall size of each battery is
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1
