Marquette BP711 EMS blood Pressure monitor 6v battery 1.2ah sealed
Replacement Marquette BP711 EMS blood Pressure monitor non-spillable sealed lead acid valve regulated 6-volt 1.2ah batteries, AGM and VRLA, offered direct from warehouse at low cost
Below you should find we have listed all of the relevant information on this page to help assist you in the renewal of a compatible battery for your Marquette BP711 EMS blood Pressure monitor, these 6-volt batteries are deep cycle capable with a energy storage of 1.2-amp hours, rechargeable and recyclable, the main component by far in the cells is lead this means they are a environmentally friendly as can very easily be made into something else, maybe another battery at the end of their life and the time comes for recycling, more information on this can be found on our recycling page
- Marquette BP711 EMS blood Pressure monitor battery replacement
The batteries you receive from us will be almost fully charged, but you should still charge them before first use, this will not be necessary only if being fitted in something that is always connected to the mains like an alarm system which will do the job for you, the charger will have LED lights which will indicate whether it is still charging or not, you only need to charge them until they are ready, probably not very long at all, you may well be impatient and use the equipment without charging but it's worth waiting until its fully charged and will help extend overall life expectancy
Unless you are a very extended user you will probably not even notice that it can take a number of charge and use in your equipment before a full capacity charge is achieved, this is all part of the conditioning process and quite normal, if being used in a portable device then ensure that after every use that you put the batteries back on charge, letting them sit in a partially discharged state is not wise, you cannot rejuvenate this kind of battery by running them down, going out of your way to fully discharge the batteries will reduce their life span, so do not do it, these batteries need to be kept charged, so if there is any reason where they are not be used then ensure they are charged beforehand and then every 4-weeks, but do not leave on a charger for more than 24-hours
These 6-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or in portable equipment without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not hazardous
So many codes on batteries are almost the same, you should carefully check them before ordering to ensure you are getting the right pack, if in doubt then look at your old one, take a note of the dimensions and anything that is written on the side, this will always be the best information to have, we have also included on the page the dimensions so you can confirm before ordering, this 6-volt 1.2ah battery is as you would expect recyclable, more detailed information on recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = AGM, VRLA, Pb
This offer is for a total of 1 quality batteries for the Marquette BP711 EMS blood Pressure monitor we have mentioned the size below of each battery for your convenience
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1
