R&D 5639 SET 6v 1.2ah battery replacement sealed lead rechargeable
Replacement R&D 5639 SET sealed lead battery pack, rechargeable system valve regulated 6-volt 1.2ah batteries, VRLA and AGM, they will not spill, safe to be mounted on the side at low competitive cost
Here you will find we have offered on the page the relevant information to help you consider the decision of purchasing a new compatible replacement battery for your R&D 5639 SET, which has a energy storage capacity of 1.2-amp hours, the cells are 6-volt and capable of deep cycling, they are as would be needed rechargeable and not-hazardous and will not spill so therefore safe to be handled and to use indoors or in portable equipment, AGM and VRLA cells, more information about these chemistries will be found below
- R&D 5639 SET battery replacement
After placing your order and upon receipt of your new battery pack you may will note that they have a good charge in them, but you should still charge them fully before using for the first time, if it's going into a device that is always connected to the mains like a battery backup for monitoring or alarm system then you can miss this step as it will do it for you, your charger will indicate to you when it has completed a charge, it will probably not take very long depending on the charger, the light will generally change to indicate its ready, do not just fit them and roll without this initial charge, it will help to extend the battery life overall
it may well take a number of charges and alternating use in your equipment for the battery to condition and be able to take a full capacity charge, this is quite normal, once you have used your portable equipment then put the batteries back on charge, do not let them sit in a partially discharged state for any longer than absolutely necessary, discharging the batteries fully will only reduce their life expectancy, you cannot kick start this kind of battery in that way, it will do them no good and will cost you money in the long run, if for any unforeseen reason they is an extended period where you are not using the batteries make sure they are fully charged first, then recharge every four weeks but do not leave on the charger for more than 24-hours
These 6-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or in portable equipment without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not hazardous
We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery, take note of the dimensions and anything written on the side of them, we have included the size below so you can double check, this 6-volt 1.2ah product is recyclable it is made mainly of lead which is easily transformed, please ensure they are disposed of properly at a recycling centre once they have completely fulfilled their useful purpose for you, more information about recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = Pb, sealed lead, VRLA, AGM
We are offering a total of 1 quality batteries for the R&D 5639 SET the physical dimensions of each battery is
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1
