Alaris Medical Sitesaver Controller 280 replacement 6-volt battery sealed
Replacement Alaris Medical Sitesaver Controller 280 battery pack, rechargeable compact, non-spillable sealed lead non-hazardous 6-volt 3.2-amp hour batteries that will not leak, can be used in portable equipment, VRLA, AGM at low competitive prices
The following information which hopefully is sufficient has been compiled to help assist you in the consideration of a new replacement compatible battery for the Alaris Medical Sitesaver Controller 280, this type of battery is often seen in portable devices including medical equipment as well as backup for alarm systems the 6v cells have a energy storage capacity of 3.2-amp hours. they are also capable of deep cycling, rechargeable, they are non-spillable and not-hazardous so it's safe to handle them and use indoors and or course in mobile applications, they have a AGM and VRLA type of cell, more information on the chemistry will be found below
- Alaris Medical Sitesaver Controller 280 battery replacement
Even though the batteries you receive from us after placing your order will be almost fully charged you should still complete a full charge before first use, if the battery is being fitted in something with its own built in always connected mains supply like an alarm system then you can miss this step as it will do a better job of charging it than you, just charge them until your charger LED lights indicate that they are ready, it will probably not take very long, try to make sure you do not miss the initial charge (unless of course being fitted in a device with own circuit as stated above), doing so may well reduce overall life expectancy
You probably will not notice but if you are using in a piece of equipment that requires outside intervention for charging that it will take up to ten charges and associated use in your device before the batteries are capable of taking a few capacity charge, this is normal, if being used in a portable piece of equipment then as soon as you after each use put them back on charge, do not allow them to sit in a discharged state, never go out of your way to try to deliberately discharge the batteries all the way down, doing so with this type of battery will only reduce the life span and cost you money in the long run, it is important to keep a charge in the batteries for long life, so if there is any period of time where they are not being used then charge before hand and top this up every four weeks but do not leave on a charger for more than 24-hours
The battery type is AGM which is short for absorbed glass mat construction, they are also valve regulated, to the end user this would mean they can be used around the home or in portable devices without the fear of any leakage, they will never need any maintenance, except of course charging, no need to top up fluids, they are sealed, the acid is held within a glass matting, very tough can withstand heat and the cold to the extreme and highly reliable
We have provided the information here purely as a guide, it would be wise to check the code carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the relevant dimensions so you can make sure you are ordering the correct one, looking at your old power pack and taking note of the dimensions and anything that may be printed on the side is probably the best thing to do, these 6-volt 3.2-amp hour batteries are recyclable, the main constructive component is lead or Pb which can easily be recycled, more information on this can be found at the bottom on this page on our recycling link
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = AGM, sealed lead, VRLA
In this set there is 1 batteries to replace the Alaris Medical Sitesaver Controller 280 the physical dimensions are as follows
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
