Cutter Labs Infusion-Pump-888 battery replacement 6-volt 3.2ah sealed
Replacement Cutter Labs Infusion-Pump-888 battery pack, valve regulated sealed lead acid compact and rechargeable 6-volt 3.2ah absorbed glass mat batteries, will not spill can be used in portable devices, offered at low prices direct from warehouse

Please find below printed on this page sufficient relevant details to help you consider the decision of purchasing a new compatible replacement battery for your Cutter Labs Infusion Pump 888, which has a energy storage capacity of 3.2-amp hours, this size battery is often used in medical devices, portable and fixed and also commercial and home alarm systems as well as other uses, the cells are 6-volt and capable of deep cycling, rechargeable and recyclable, the main component used in the manufacture of the cells is lead it follows then that they are a environmentally friendly as can very easily be made into something else, maybe another battery at the end of their life and the time comes for recycling, more information on this can be found on our recycling page

• Infusion-Pump-888 battery 

When you place an order and it is delivered to you the batteries will be almost fully charged, but regardless of this you should still complete a charge them before first use, however if it's a battery backup for something that's always connected to the mains with its own built in charging circuit like a monitor or maybe a alarm system then you do not need to charge it first as the system will do that for you, your charger will indicate to you when it has completed this first charge, it will probably not take very long depending on the charger, the light will generally change to indicate its ready, you may well just want to fit them and use the equipment, but do try not miss this first step, if needed that is, it's worth waiting until the first charge has completed and it may well contribute to over life span

You probably will not notice but if you are using in a piece of equipment that requires outside intervention for charging that it will take up to ten charges and associated use in your device before the batteries are capable of taking a few capacity charge, this is normal, allowing your new batteries to sit without any charge in them is not a certainly not a good idea so it follows that if using them in a portable device as soon as you have finished using it put it back on charge, never go out of your way to try to deliberately discharge the batteries all the way down, doing so with this type of battery will only reduce the life span and cost you money in the long run, it is important to keep a charge in the batteries for long life, so if there is any period of time where they are not being used then charge before hand and top this up every four weeks but do not leave on a charger for more than 24-hours

The battery type is AGM which is short for absorbed glass mat construction, they are also valve regulated, to the end user this would mean they can be used around the home or in portable devices without the fear of any leakage, they will never need any maintenance, except of course charging, no need to top up fluids, they are sealed, the acid is held within a glass matting, very tough can withstand heat and the cold to the extreme and highly reliable

The information we have provided on this page should only be used as a guide, you should carefully check before ordering as many are very similar, if still in doubt you can look at your old battery, take a note of the dimensions and anything that may be written on the side of them, this will always be the best way, we have also included the physical dimensions on this page so you can confirm, these 6v 3.2ah batteries are constructed mainly from lead which is easy to recycle and transform into another product so therefore environmentally friendly, more information regarding recycling will be found at a link at the foot of this page

Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = valve regulated lead acid, VRLA, AGM

This set contains 1 rechargeable and recyclable batteries for the Cutter Labs Infusion-pump-888 the overall size of each battery is
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1