Skip to Main Content

Datex Medical 2000 Normo Cap sealed battery pack 6v AGM 3.2ah

£26.98 inc. VAT

Images for assistance only.
Share This Product
  • Model:BT630-26061
  • Battery Charge:Rechargeable
  • Battery Voltage:6.00 Volts
  • Battery Capacity:3.00 Ah
  • Battery Chemistry:AGM
  • Condition:New
  • Pack Contains:1
  • Shipping Weight:0.65 Kilos

Datex Medical 2000 Normo Cap sealed battery pack 6-volt AGM 3.2ah
Replacement Datex Medical 2000 Normo Cap battery pack, rechargeable compact, non-spillable sealed lead non-hazardous 6-volt 3.2-amp hour batteries that will not leak, can be used in portable equipment, VRLA, AGM at low competitive prices

On this page we have hopefully offered sufficient relevant information to help you consider the decision of purchasing a new compatible replacement battery for your Datex Medical 2000 Normo Cap, with a capacity of 3.2-amp hours, you might find this size battery in medical equipment, portable and stationary as well as home and commercial alarm systems as emergency battery backup as well as many other uses, these 6-volt cells are also capable of deep cycling, they are safe to be handled and to use indoors or in portable devices as well of course as rechargeable they are made for this kind of application, they are the required VRLA with AGM technology (more information about the qualities of the chemistry of them will be found below) they are recyclable and very environmentally friendly, see our recycle page for details

  • Datex Medical 2000 Normo Cap battery replacement

This sealed lead battery that you obtain from us will be almost fully charged, but you should still charge them fully before first use, if it's going into a device that is always connected to the mains and has its own charging circuit like a battery backup for monitoring or alarm system then you can miss this step as it will do it for you, the period of this initial charge before first use need only be until the charger states it is ready, probably not very long at all, do not miss out this very important first step, it will help set them up properly and possibly extend the possible overall life expectancy of them

It will probably not even be apparent but if being used in a more portable device it will take a few charges and associated use in your device before the battery is capable of receiving a full capacity charge, this is quite normal, if being used in a portable device then you should make sure that after every use that you put the batteries back on charge, letting them sit in a partially discharged state is not wise, you cannot rejuvenate this kind of battery by deliberately running them down, going out of your way to fully discharge the batteries will reduce their life span, so do not do it, it is important to keep a charge in the batteries for long life, so if there is any period of time where they are not being used then charge before hand and top this up every four weeks but do not leave on a charger for more than 24-hours

These 6-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or in portable equipment without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not hazardous

Please note you should use all the information on this page only a guide, while we have tried very hard here to assist you in getting the correct battery, it should be noted that there are many very similar codes, if you are not sure you should always double check what you have before ordering, this may also give you the opportunity to see how easy it is going to be to change them, take note of the dimensions and anything written on the side of them, all the physical sizes are listed on this page, these 6-volt 3.2-amp hour batteries are recyclable, the main constructive component is lead or Pb which can easily be recycled, more information on this can be found at the bottom on this page on our recycling link

Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = absorbed glass mat, AGM, VRLA

There is 1 batteries to replace the Datex Medical 2000 Normo Cap the overall dimensions of each battery are
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1

Datex Medical 2000 Normo Cap terminal layout battery guide


Frequently Asked Questions

Ask us a question

There are no Videos for this particular Product.
View our other help, technical, installation and information videos.

Installation Videos

We do have other Videos, subscribe to our Youtube Channel using the Button below.
Supplementary Files: None available

  • 98% of orders shipped same day for next day working day delivery in UK Mainland
  • FREE Delivery on orders of £45 and over in most of UK Mainland
  • We ship Worldwide, add to cart for delivery cost
  • You can return any order for any reason, in resaleable condition, within 14 days
  • Our full delivery and returns details can be viewed in the footer
Explore
0 item(s), £0.00

0 items