Hewlett Packard 14200019 rechargeable 6-volt 3.2ah battery AGM
Replacement Hewlett Packard 14200019 battery set, valve regulated safe non-spillable small 6-volt 3.2ah rechargeable batteries, they are AGM and VRLA, they can be used in portable equipment offered at low competitive price direct from warehouse
Below you should find we have listed most of the relevant information that you would need to help assist you in the renewal of a compatible battery for your Hewlett Packard 14200019, this type of battery is often seen in portable medical equipment as well as alarm systems as a emergency battery backup, they can store 3.2-amp hours of energy in the 6-volt cells and capable of deep cycling, rechargeable and recyclable, the main component used in the manufacture of the cells is lead it follows then that they are a environmentally friendly as can very easily be made into something else, maybe another battery at the end of their life and the time comes for recycling, more information on this can be found on our recycling page
- Hewlett Packard 14200019 battery replacement
After placing you and receipt of your order you will note that the batteries will be almost fully charged when received, but you should still maintain a full charge before first use, if it's going into a device that is always connected to the mains and has its own charging circuit like a battery backup for monitoring or alarm system then you can miss this step as it will do it for you, your charger will indicate to you when it has completed this first charge, it will probably not take very long depending on the charger, the light will generally change to indicate its ready, this first step is important so please do ignore it, unless of course as otherwise stated above, do not use without this initial charge, doing so can shorten expected life span
Most users will not even notice but if being used in a more mobile device it may take a number of charges and associated use in your equipment before they are capable of accepting a full capacity charge, this is quite normal and part of the conditioning process, you should fully charge your batteries as soon as you can after every use if they are being used in a portable device, do not leave them sitting in a semi discharged state any period unless necessary, never go out of your way to try to deliberately discharge the batteries all the way down, doing so with this type of battery will only reduce the life span and cost you money in the long run, if for any unforeseen reason they is an extended period where you are not using the batteries make sure they are fully charged first, then recharge every four weeks but do not leave on the charger for more than 24-hours
These batteries are deep cycle capable, which is essential in this type of application, the VRLA and AGM cells will not leak as the acid is combined within a glass matting so no liquid, not-hazardous so suitable for travelling, there is no maintenance required, except of course charging which we have covered on this page.
The information we have provided on this page should only be used as a guide, you should carefully check before ordering as many are very similar, if still in doubt you can look at your old battery, take a note of the dimensions and anything that may be written on the side of them, this will always be the best way, we have also included the physical dimensions on this page so you can confirm, these 6-volt 3.2ah batteries are recyclable, the overlaying main constructed content is lead which is very easily transformed into another useful product, maybe even another battery, more information about recycling can be found on our recycling page, link to which is at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = sealed lead acid, VRLA, AGM
We are offering 1 quality lead acid batteries for the Hewlett Packard 14200019 we have mentioned the size below of each battery for your convenience
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
