Impact Instrumentation suction Pump 302 replacement 6-volt battery
Replacement Impact Instrumentation suction Pump 302 battery pack, rechargeable small 6-volt valve regulated sealed lead acid mobility batteries rated at 3.2ah non-spillable suitable for portable equipment

On this page you will find we have hopefully listed all of the required data for you to make a educated decision to support your consideration of a purchase of a new replacement compatible battery for the Impact Instrumentation suction Pump 302, this type of battery is often seen in portable medical equipment as well as alarm systems as a emergency battery backup, they can store 3.2-amp hours of energy in the 6-volt cells and capable of deep cycling, they are safe to be handled and to use indoors or in portable devices as well of course as rechargeable they are made for this kind of application, they are the required VRLA with AGM technology (more information about the qualities of the chemistry of them will be found below) they are recyclable and very environmentally friendly, see our recycle page for details

• Impact Instrumentation suction Pump 302 battery replacement

After placing your order and receiving your new battery from us you may will note that they have a good charge in them, but you should still charge it fully before using for the first time, this will not be necessary only if being fitted in something that has its own built in charger that is always connected to the mains like an alarm system which will do the job for you, your charger will indicate to you when it has completed this first charge, it will probably not take very long depending on the charger, the light will generally change to indicate its ready, while you may well be tempted just to fit without charging if it's going in a portable device its worth completing the charge first as it may well extend the life of them

It will probably not even be apparent but if being used in a more portable device it will take a few charges and associated use in your device before the battery is capable of receiving a full capacity charge, this is quite normal, allowing your new batteries to sit without any charge in them is not a certainly not a good idea so it follows that if using them in a portable device as soon as you have finished using it put it back on charge, never go out of your way to deliberately discharge the batteries, it will not rejuvenate them, with this type of technology it will only mean a shorter life, it is important to keep a charge in the batteries for long life, so if there is any period of time where they are not being used then charge before hand and top this up every four weeks but do not leave on a charger for more than 24-hours

These are 6-volt valve regulated sealed lead acid batteries and will not leak, sealed lead acid, the acid is held within a glass mattering and will not leak, no maintenance is required, they are both AGM and VRLA, of course they are the required deep cycle kind and they are not-hazardous so safe for use in portable equipment, medical and indoors

So many codes on batteries are almost the same, it would be prudent to carefully check them before ordering to ensure you are getting the right pack, if in doubt then look at your old one, take a note of the dimensions and anything that is written on the side, this will always be the best information to have, we have also included on the page the dimensions so you can confirm before ordering, these 6v 3.2ah batteries are constructed mainly from lead which is easy to recycle and transform into another product so therefore environmentally friendly, more information regarding recycling will be found at a link at the foot of this page

Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = VRLA, AGM

There is 1 rechargeable and recyclable batteries for the Impact Instrumentation suction Pump 302 the dimensions of the individual battery pack are as follows
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1