Johnson Controls GC626 battery replacement 6-volt 3.2ah sealed AGM
Replacement Johnson Controls GC626 rechargeable compact 6-volt 3.2ah battery pack, valve regulated VRLA sealed AGM, safe non-spillable batteries which can be used in portable devices direct from warehouse at low price

Below you should find we have listed most of the relevant information that you would need to help assist you in the renewal of a compatible battery for your Johnson Controls GC626, these 6-volt batteries are often seen in portable medical equipment or back up in alarm systems, they are deep cycle capable with a energy storage of 3.2-amp hours, which are, as would be of course be required, rechargeable, they are safe to use indoors they will not spill, non-hazardous, AGM and VRLA construction of cells, much more information about the qualities of these unique chemistries can be found below

• Johnson Controls GC626 battery replacement

After you have made and unpacked your new battery from us you will note that they will have a good charge in them, regardless of this you should still complete a full maintenance charge before first use, if the battery is being fitted in something with its own built in always connected mains supply like an alarm system then you can miss this step as it will do a better job of charging it than you, you do not need to leave it on for hours on end its almost fully charged, it will probably not take very long at all depending on the charger, just until the charger has indicated that it has finished, while you may well be tempted just to fit without charging if it's going in a portable device its worth completing the charge first as it may well extend the life of them

You probably will not notice but if you are using in a piece of equipment that requires outside intervention for charging that it will take up to ten charges and associated use in your device before the batteries are capable of taking a few capacity charge, this is normal, allowing your new batteries to sit without any charge in them is not a certainly not a good idea so it follows that if using them in a portable device as soon as you have finished using it put it back on charge, never go out of your way to deliberately discharge fully, this type of technology is not suitable for that kind of treatment, this will only reduce overall life span, if for any reason you are not using them for long periods then you should recharge every 4 to 6-weeks but do not leave on the charger for more than 24-hours at a time

The battery type that we are offering here is VRLA and AGM, they need no maintenance, no topping up of fluids, the acid is suspended within a glass matting, they are sealed lead acid and valve regulated with AGM technology, they are not-hazardous and safe to use around the home or in portable devices well as travelling

We have provided the information here purely as a guide, it would be wise to check the code carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the relevant dimensions so you can make sure you are ordering the correct one, looking at your old power pack and taking note of the dimensions and anything that may be printed on the side is probably the best thing to do, these 6-volt 3.2ah batteries are made mainly of lead which is deemed easy to be recycled, more information about recycling can be found at the foot of this page

Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = Pb, sealed lead acid, VRLA, AGM

We are offering a total of 1 rechargeable and recyclable batteries for the Johnson Controls GC626 the overall dimensions of each battery are
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1