Medical Technology P 1000 Infusion Pump rechargeable 6v battery 3.2ah
Replacement Medical Technology P 1000 Infusion Pump battery pack, valve regulated sealed lead acid compact and rechargeable 6-volt 3.2ah absorbed glass mat batteries, will not spill can be used in portable devices, offered at low prices direct from warehouse
We have tried to list here, and hopefully succeeded on this page all the relevant information to help you make the decision of purchasing a new replacement compatible battery for your Medical Technology P 1000 Infusion Pump, which can be seen in medical devices portable and fixed as well as alarm systems are 6-volt and 3.2ah and capable of deep cycling, they are as would be needed rechargeable and not-hazardous and will not spill so therefore safe to be handled and to use indoors or in portable equipment, AGM and VRLA cells, more information about these chemistries will be found below
- Medical Technology P 1000 Infusion Pump battery replacement
After placing you and receipt of your order you will note that the batteries will be almost fully charged when received, but you should still maintain a full charge before first use, if the battery is being fitted in something with its own built in always connected mains supply like an alarm system then you can miss this step as it will do a better job of charging it than you, it shouldn't take long as its almost fully charged already, just until the charger lights indicates its ready, if really in doubt overnight will be more than enough but it's doubtful you would need to leave it on the charger that long, while you may well be tempted just to fit without charging if it's going in a portable device its worth completing the charge first as it may well extend the life of them
Unless you are a very extended user you will probably not even notice that it can take a number of charge and use in your equipment before a full capacity charge is achieved, this is all part of the conditioning process and quite normal, if being used in a portable device then you should make sure that after every use that you put the batteries back on charge, letting them sit in a partially discharged state is not wise, you should never deliberately go out of your way to try fully discharge the batteries, we are often asked will this extend the life but no this will only reduce its life span and cost you money in the long run, these batteries need to be kept charged, so if there is any reason where they are not be used then ensure they are charged beforehand and then every 4-weeks, but do not leave on a charger for more than 24-hours
The battery type that we are offering here is VRLA and AGM, they need no maintenance, no topping up of fluids, the acid is suspended within a glass matting, they are sealed lead acid and valve regulated with AGM technology, they are not-hazardous and safe to use around the home or in portable devices well as travelling
We have provided the information here purely as a guide, it would be wise to check the code carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the relevant dimensions so you can make sure you are ordering the correct one, looking at your old power pack and taking note of the dimensions and anything that may be printed on the side is probably the best thing to do, this 6-volt 3.2ah battery is as you would expect recyclable, the main component is lead, more detailed information on recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = sealed lead acid, VRLA, AGM
In this pack there are a total of 1 rechargeable and recyclable batteries for the Medical Technology P 1000 Infusion Pump the overall dimensions of each battery are
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
