Medical Technology P MVP1 Infusion Pump 6-volt 3.2ah battery AGM
Replacement Medical Technology P MVP1 Infusion Pump rechargeable battery pack, small valve regulated sealed lead 6-volt 3.2-amp hour batteries often seen in portable devices or as backup with both VRLA and AGM technology, at low competitive price direct from warehouse
On this page we have hopefully offered sufficient relevant information to help you consider the decision of purchasing a new compatible replacement battery for your Medical Technology P MVP1 Infusion Pump, this type of battery is often seen in portable devices including medical equipment as well as backup for alarm systems the 6v cells have a energy storage capacity of 3.2-amp hours. they are also capable of deep cycling, these are of course as would be needed in such installations rechargeable, they are non spillable, safe and not-hazardous so safe to be handled, stored and used indoors, the cell structure is a composite of lead which is formed as AGM and VRLA, more information on these construction processes can be found below
- Medical Technology P MVP1 Infusion Pump battery replacement
After you have made and unpacked your new battery from us you will note that they will have a good charge in them, regardless of this you should still complete a full maintenance charge before first use, if the battery is being fitted in something with its own built in always connected mains supply like an alarm system then you can miss this step as it will do a better job of charging it than you, the charge time will depend on your charger but as its almost fully charged it will not be long, just leave it on until it indicates its finished, do not just install and use without this initial charge, unless the situation is as stated above, doing so can shorten expected life span, it's well worth doing
If being used in a portable device it may well take a number of charges and alternating use in your equipment for the battery to condition and be able to take a full capacity charge, this is quite normal, allowing your new batteries to sit without any charge in them is not a certainly not a good idea so it follows that if using them in a portable device as soon as you have finished using it put it back on charge, do not try to attempt to fully discharge the batteries, it will not rejuvenate them, in fact the opposite, it will reduce the lifespan and cost you money in the long run, there may be many reasons for the equipment not be used on a regular basis, if there are protracted periods where this is the case then ensure the batteries are charged before hand and then topped up every four weeks but do not leave on a charger for more than 24-hours at a time
These are 6-volt valve regulated sealed lead acid batteries and will not leak, sealed lead acid, the acid is held within a glass mattering and will not leak, no maintenance is required, they are both AGM and VRLA, of course they are the required deep cycle kind and they are not-hazardous so safe for use in portable equipment, medical and indoors
So many codes on batteries are almost the same, it would be prudent to carefully check them before ordering to ensure you are getting the right pack, if in doubt then look at your old one, take a note of the dimensions and anything that is written on the side, this will always be the best information to have, we have also included on the page the dimensions so you can confirm before ordering, as these 6-volt 3.2ah batteries are manufactured mainly from lead they are recyclable, this is of course environmentally friendly, more information about recycling can be found on a link at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = valve regulated lead acid, VRLA, AGM
We are offering 1 quality lead acid batteries for the Medical Technology P MVP1 Infusion Pump the overall dimensions of each battery are
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
