Powertron H1X3DSW replacement 6-volt battery sealed lead AGM
Replacement Powertron H1X3DSW battery pack, rechargeable compact, non-spillable sealed lead non-hazardous 6-volt 3.2-amp hour batteries that will not leak, can be used in portable equipment, VRLA, AGM at low competitive prices

Below you will hopefully find we have entered all of the relevant details for you to decide on the purchase of a new compatible battery you will require for the Powertron H1X3DSW, they are 6-volt with 3.2ah of energy storage often seen as alarm backup energy and in medical devices including portable and capable of deep cycling, these are of course as would be needed in such installations rechargeable, they are non spillable, safe and not-hazardous so safe to be handled, stored and used indoors, the cell structure is a composite of lead which is formed as AGM and VRLA, more information on these construction processes can be found below

• Powertron H1X3DSW battery replacement

When you place an order and it is delivered to you the batteries will be almost fully charged, but regardless of this you should still complete a charge them before first use, if the battery is being fitted in something with its own built in always connected mains supply like an alarm system then you can miss this step as it will do a better job of charging it than you, there should be no need for many hours, it will probably not take very long at all as its almost fully charged already, just until your charger indicates they are ready, this will of course depend on the charger capabilities, do not just fit them without this initial charge, it will not take long anyway, it will not take long as it is almost fully charged anyway and it may help to extend the battery life overall

Unless you are a very extended user you will probably not even notice that it can take a number of charge and use in your equipment before a full capacity charge is achieved, this is all part of the conditioning process and quite normal, each time you have used your battery in a more portable device then you should put it back on charge as soon as you can, it is not wise to leave it sitting in a semi discharged state for any longer than necessary, discharging the batteries fully will only reduce their life expectancy, you cannot kick start this kind of battery in that way, it will do them no good and will cost you money in the long run, they may be protracted periods where the batteries are not being used, if this is the case ensure they are fully charged first, then top up every four weeks but do not leave on a charger for more than 24-hours

These batteries will require no general maintenance, no topping up with fluid as it has none, the acid is suspended within a glass matting between the plates so will not spill, they are AGM and VRLA, of course with deep cycle properties that would be required in this type of application, they are also not-hazardous so safe to use in the home or in portable devices

Check the information carefully to ensure you are ordering the correct battery as many of them have very similar codes, if in doubt the dimensions of the batteries are probably your best guide and take note of anything that may be written on the side of them, the size of is also specified below so you can confirm, this 6-volt 3.2ah battery is as you would expect recyclable, the main component is lead, more detailed information on recycling can be found at the foot of this page

Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = AGM, sealed lead, VRLA

There is a total of 1 ready to install batteries for the Powertron H1X3DSW here is the dimensions of a single battery
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1