PPG Biomedical EK31, EK32, EK33 monitor rechargeable 6v battery 3.2ah
Replacement PPG Biomedical EK31, EK32, EK33 monitor batteries, rechargeable valve regulated sealed lead 6-volt 3.2-amp hour compact non-spillable battery, can be used in portable devices, available at low competitive price direct from warehouse
Please find below the information on this page that we have compiled so you can make a educated decision on the purchase of a new replacement compatible battery for the PPG Biomedical EK31, EK32, EK33 monitor, they are 6-volt with 3.2ah of energy storage often seen as alarm backup energy and in medical devices including portable and capable of deep cycling, they are of course rechargeable, these non-hazardous AGM and VRLA cells are safe to handle and to use around the home or in portable devices, more information about the qualities of the chemistry make up will be available below
- PPG Biomedical EK31, EK32, EK33 monitor battery replacement
Upon receipt of your order from us the batteries will be almost fully charged but even so you will still need to complete a charge before first use, the only time you do not need to do this is if it's going into something with its own always connected power supply and charging circuit, for example a alarm system, as this will do the job of charging for you, you do not need to leave it on for hours on end its almost fully charged, it will probably not take very long at all depending on the charger, just until the charger has indicated that it has finished, do not just install and use without this initial charge, unless the situation is as stated above, doing so can shorten expected life span, it's well worth doing
While is not something that most will even notice but if being used in a portable piece of equipment it could take a number of charges and corresponding use in the device before a full capacity charge is reached, this is a normal part of the conditioning process, once you have used your portable equipment then make sure you put the batteries back on charge afterwards, do not let them sit in a partially discharged state for any longer than absolutely necessary, we have heard of people trying to extend battery life by running them all the way down, do not attempt this with this kind of technology, fully discharging your new batteries will only reduce the overall life span and they will need changing earlier, this will cost you money in the long run, these batteries need to be kept charged, so if there is any reason where they are not be used then ensure they are charged beforehand and then every 4-weeks, but do not leave on a charger for more than 24-hours
These 6-volt batteries are manufactured as AGM (absorbed glass mat) and VRLA (valve regulated lead acid) to the end user it means they are very versatile, they are sealed lead acid, the acid being suspended within a glass mat so will not leak and not-hazardous so can be used indoors or in portable devices, they also need no maintenance whatsoever, except of course charging
You should confirm the code on your old battery carefully, there are many that are very similar so you want to order the correct one, check the dimensions and take note of anything written on the side of them, we have also included the physical dimensions below so you can make certain you are ordering the correct one, this 6-volt 3.2ah battery is as you would expect recyclable, the main component is lead, more detailed information on recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = VRLA, AGM, sealed lead, Pb
You will find a total of 1 rechargeable and recyclable batteries for the PPG Biomedical EK31, EK32, EK33 monitor here is the dimensions of a single battery
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
