PPG Biomedical System GB626 6-volt battery replacement sealed AGM
Replacement PPG Biomedical System GB626 sealed lead battery pack, rechargeable and compact valve regulated 6-volt 3.2ah batteries, used as battery backup or in portable devices, VRLA and AGM, they will not spill, safe to be mounted on the side at low competitive cost

On this page we have hopefully offered sufficient relevant information to help you consider the decision of purchasing a new compatible replacement battery for your PPG Biomedical System GB626, they are 6-volt with 3.2ah of energy storage often seen as alarm backup energy and in medical devices including portable and capable of deep cycling, as you would expect they are rechargeable and not-hazardous, they will not spill so safe to be handled and for use indoors as well as more portable applications, they are also recyclable and environmentally friendly, more information on recycling can be found on our recycle page

• PPG Biomedical System GB626 battery replacement

The battery pack that you receive from us will be almost fully charged, but you should still charge them before first use, if it's going into a device that is always connected to the mains and has its own charging circuit like a battery backup for monitoring or alarm system then you can miss this step as it will do it for you, you do not need to leave it on for hours on end its almost fully charged, it will probably not take very long at all depending on the charger, just until the charger has indicated that it has finished, this first step is important so please do ignore it, unless of course as otherwise stated above, do not use without this initial charge, doing so can shorten expected life span

It's not always apparent but if you are using the battery in device that requires user action for the charging of it that it may take up to ten charges combined with use in your equipment before a full capacity charge can be achieved, this is just a normal part of the conditioning process, letting your new batteries sit in a discharged state, even partially is not a good idea, so if being used in a portable device as soon as you have used them put them back on charge, never go out of your way to deliberately discharge fully, this type of technology is not suitable for that kind of treatment, this will only reduce overall life span, if it turns out there are periods where the equipment is not being used on a regular basis then ensure the batteries are fully charged before any period of downtime and then topped up every four weeks but do not leave on the charger for more than 24-hours

The battery type is AGM which is short for absorbed glass mat construction, they are also valve regulated, to the end user this would mean they can be used around the home or in portable devices without the fear of any leakage, they will never need any maintenance, except of course charging, no need to top up fluids, they are sealed, the acid is held within a glass matting, very tough can withstand heat and the cold to the extreme and highly reliable

You should confirm the code on your old battery carefully, there are many that are very similar so you want to order the correct one, check the dimensions and take note of anything written on the side of them, we have also included the physical dimensions below so you can make certain you are ordering the correct one, this 6-volt 3.2-amp hour uses a very high content of lead or PB in its manufacture, this is very easy to recycle so it can further be used in another product, more information on this process can be found on our recycle page link at the foot of this one

Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = Pb, sealed lead acid, VRLA, AGM

In this set you will find a quantity of 1 quality lead acid batteries for the PPG Biomedical System GB626 the physical size of the individual batteries are as follows
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1