APC AP1200 UPS battery pack replacement sealed lead VRLA AGM
Replacement APC AP1200 UPS battery pack, rechargeable sealed lead acid, safe non-spillable valve regulated VRLA batteries with advanced AGM technology at low competitive cost
Here you will find we have compiled data to help you make a informed decision the purchase new batteries for your APC AP1200, the onboard energy storage facility which give you the runtime back up also helps to filter the mains input supply before releasing on to your valuable equipment behind it without surges and is powered by way of 12v cells, and comes with 2 x 12-volt batteries which is what the offer on this page is, as you would expect they are rechargeable and not-hazardous they are also recyclable to give them a long life and environmentally friendly, more information on recycling can be found on our recycle page
- APC AP1200 battery replacement
Installing the batteries in not a difficult job, well within the capabilities of most people, you should refer to your manual for the method, they are designed to be replaced, the ones we send to you will be almost fully charged but the UPS will still complete a service charge upon installation, so it of course follows that there will be a period of time where you do not have the full protection that your UPS could offer until it has completed this operation, if you can it would be best to allow the initial charge without any load to start, we know this may not be convenient in a lot of installations but that is best advise it's up to you whether you heed it
In this UPS you could expect the batteries to last somewhere between two to five years, this will of course be very dependent on its general use, sufficient ventilation is important, preferably in a air conditioned communications room, batteries will in general use get hot if the heat cannot disperse it will shorten life span, keep an eye on the load, do not have to many devices connected, if you can keep it below 40% it will last longer, while its more than capable of going higher it will be at the expense of the battery life
These batteries are sealed lead valve regulated or VRLA and benefit from AGM technology, this means they will not spill so can be mounted on the side in a UPS without fear of leakage, they can be used in rack or tower modules, they are not-hazardous so safe for use in mission critical environments including busy data centres or hospitals
Please note you should us the information on this page is only a guide, we have tried to assist you in getting the correct batteries for your UPS system, there are many very similar codes, if you are not sure you can always check what you have before ordering, this will also give you the opportunity to see how easy it is going to be to change the batteries, if you look very closely at the product code on your UPS then you shouldn't go wrong. The batteries are recyclable, more information on recycling can be found at the foot of this page.
Voltage = 12-volts
Capacity = 26Ah @20Hr
Chemistry = Pb, sealed lead, VRLA, AGM
Hot swap capable
In this set there is 2 rechargeable lead acid batteries for the APC AP1200 the overall size of each battery is
Length = 166mm
Width = 175mm
Height = 125mm
Battery layout - from chart below = 0
