Mustek PowerMUST-600 UPS battery set replacement sealed VRLA AGM
Replacement Mustek PowerMUST-600 sealed lead battery pack, rechargeable UPS system valve regulated batteries, VRLA and AGM, they will not spill, safe to be mounted on the side at low competitive cost
Here you will find we have compiled the relevant data to help you make a informed decision about the purchase of new batteries for your Mustek PowerMUST-600, the onboard energy storage which give you the required runtime back up facility also helps to filter and smooth out the mains input supply before releasing a clean version on to your valuable equipment behind it without surges and is powered by way of 12-volt cells, this system comes with 1 x 12v batteries and that is what we are offering on this page which are rechargeable, safe and not-hazardous non-spillable AGM and VRLA type of cell with deep cycle properties which would be needed in this type of equipment
- Mustek PowerMUST-600 battery
The batteries that you receive from us will be almost fully charged but the system will still need to complete a service charge after installation, of course while this charge going on your UPS will not be in a position to offer the full runtime protection until its finished this, you will find its better to allow the system to run without load to start while it completes the first charge to reset the new battery energy level
A reasonable life span of batteries is between two to five years, the usage over time however will determine this, supplying adequate ventilation is important, the batteries are being continuously used 24/7 the hotter they are allowed to get the shorter the life expectancy, the higher the constant load applied the harder its working which directly relates to battery life, if you can try to keep it below 40%
These are valve regulated sealed lead acid batteries and will not leak so there will be no problem installing them in either tower or rack systems as they can be fitted on their side, both AGM and VRLA, they are not-hazardous so safe for busy data centres, medical back up as well of course as the home office
We have provided the information here as a guide, you should carefully check the code on your UPS as many of them are very similar so it's easy to make a mistake, the batteries are recyclable, more information about recycling can be found on our recycling page, link to which is at the foot of this page
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, sealed lead, VRLA
Hot swap capable
This lead acid battery is for the Mustek PowerMUST-600 UPS the overall dimensions of each battery are
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5

If you prefer we can offer this battery in a 9Ah format, it's the same dimensions and will slip straight in, a very easy upgrade that will offer you more runtime, the link to it will be just a little bit further down the page