Eaton Powerware 9120 5000 UPS battery pack replacement VRLA
Replacement Eaton Powerware 9120 5000 UPS battery set, valve regulated safe non-spillable rechargeable batteries they are AGM and VRLA at low competitive price direct from warehouse

You are probably visiting this page because your Eaton UPS is bleeping away with a not so pleasant tone stating it would like new batteries, this is not something to be wary of but it's not a good idea to delay as its do a job of protecting valuable data behind it, it's not a difficult job and will need to done every few years unless you have money to throw away and buy a new unit every time, below you will find details of the battery for your Eaton Powerware 9120 5000, the system uses batteries to filter the input electricity and output a clean supply to protect your equipment behind it they are 12v cells, and comes with 20 x 12-volt batteries and that is what this offer is for, as you would expect they are rechargeable and as they are also recyclable to give them a long life and of course environmentally friendly, more information on recycling can be found on our recycle page

• Eaton Powerware 9120 5000 battery replacement

We will send you batteries that are almost fully charged, your UPS will finish off the charge which helps it reset to the battery cell itself, during this period you should note that your system will not be able to offer you its full runtime protection until it has finished this task, we know it will not always be convenient as everything is a rush now days but if you can its best to run the system without any load to start

In this kind of device you would expect the batteries to last somewhere between two to five years, this can vary greatly on conditions, using the system as part of the office furniture is not the best idea, it needs ventilation, the batteries will get very hot as they are working hard 24-hours a day, the more heat the shorter their life, also do not overload, if you can keep the load below 40%, while the system will be more than capable of going higher than that it pays the price of working the battery cell harder which means a shorter life span

The cells are absorbed glass mat or AGM, they are also valve regulated sealed lead acid or VRLA, this is the recommended type of battery for this installation, they will not leak if mounted on the side so safe to be used in tower or rack mountable configuration with fear of spillage in mission critical applications as well as the home office

Check the code on your system carefully so you order the right battery set, the batteries are made mainly from lead and recyclable, more information on recycling can be found at the foot of this page.

Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable

In this set there is 20 ready to install batteries for the Eaton Powerware 9120 5000 we have listed the size of each battery below
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5

If you prefer we can offer this battery in a 9Ah format, it's the same dimensions and will slip straight in, a very easy upgrade that will offer you more runtime, the link to it will be just a little bit further down the page