Eaton Powerware 5125 RM 1000 UPS battery pack replacement
Replacement Eaton Powerware 5125 RM 1000 UPS battery pack, rechargeable sealed lead non-hazardous batteries that will not leak, can be used on their side, VRLA, AGM at low competitive prices
On this page we are offering you comprehensive details of a set of replacement batteries for the Eaton Powerware 5125 RM 1000, the power supply has batteries that clean up the mains electricity that is inputted by passing through the cells before it reaches the equipment behind it, they are 12v cells, and comes with 4 x 12-volt batteries and that is what this offer is for which are rechargeable, they are safe and will not spill, they are working the entire time the equipment is one so they do a lot of work over the years
- Eaton Powerware 5125 RM 1000 battery replacement
Even though the batteries we send to you will almost be fully charged the UPS will still need to complete a full charge, so there will be a period of time where you do not have the full protection that it can offer until it has completed this operation, while it may not be convenient it is best to run without load to start so it can fully reset itself to the new energy level
Batteries in this kind of installation will have a life span of between 2 to five years, this will be very dependent on the use and the way the system is stored, good ventilation, if it's in a office do not use it as a book shelf, keeping the load low will extend the life span, in a ideal world below 40%, they are so often run to the edge of their capabilities, while they may be able to do it its reducing the life span
Batteries will require no maintenance, they are AGM and VRLA, they are also not-hazardous, they can be used in rack mountable or tower systems as they will not leak if mounted on the side
Ensure that you order the right battery by checking the code on your UPS and comparing it to the information here, many are very similar, these hot swap capable batteries are recyclable, more information on this can be found at the bottom on this page on our recycling link.
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
This set contains 4 rechargeable lead acid batteries for the Eaton Powerware 5125 RM 1000 the overall size of each battery is
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5

If you prefer we can offer this battery in a 9Ah format, it's the same dimensions and will slip straight in, a very easy upgrade that will offer you more runtime, the link to it will be just a little bit further down the page