Eaton Powerware PW5119-2000 UPS battery pack replacement
Replacement Eaton Powerware PW5119-2000 sealed lead battery pack, rechargeable UPS system valve regulated batteries, VRLA and AGM, they will not spill, safe to be mounted on the side at low competitive cost

On this page we are offering you comprehensive details of a set of replacement batteries for the Eaton Powerware PW5119-2000, the system uses batteries to filter the input electricity and output a clean supply to protect your equipment behind it they are 6v cells, and comes with 8 x 6-volt batteries and that is what this offer is for these are rechargeable, non-spillable safe AGM, VRLA and capable of deep cycling which is vital in this sort of installation where they are constantly being used 24-hours a day

• Eaton Powerware PW5119-2000 battery replacement

Even though the batteries we send to you will almost be fully charged the UPS will still need to complete a full charge, so there will be a period of time where you do not have the full protection that it can offer until it has completed this operation, while it may not be convenient it is best to run without load to start so it can fully reset itself to the new energy level

Batteries in this kind of installation will have a life span of between 2 to five years, this will be very dependent on the use and the way the system is stored, ensure there is always good ventilations around the device, do not allow it to be used as a filing cabinet, if the batteries overheat it shortens the life span, also do not overload, if you can keep the load below 40%, while the system will be more than capable of going higher than that it pays the price of working the battery cell harder which means a shorter life span

These valve regulated sealed lead acid batteries will not leak so they can be mounted in tower or rack systems as they can be fitted on their side, they are not-hazardous so safe for busy data centres as well of course as the home office

Please note that the information on this page is only a guide, we have tried to assist you in getting the correct batteries for your UPS system, if you are not sure you can always check what you have before ordering, this will also give you the opportunity to see how easy it is going to be to change the batteries, if you look closely at the product code on your UPS then you shouldn't go wrong.

Voltage = 6-volts
Capacity = 10Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable

There are 8 rechargeable batteries as used in the Eaton Powerware PW5119-2000 the overall dimensions of each battery are
Length = 151mm
Width = 51mm
Height = 94mm
Battery layout - from chart below = 1

Hot swap capable, no maintenance required