APC AP200 replacement UPS battery set sealed lead AGM
Replacement APC AP200 UPS battery set, valve regulated safe non-spillable rechargeable batteries they are AGM and VRLA at low competitive price direct from warehouse
Below you will find we have given more information to help you make the decision to buy new batteries for your APC AP200, it stores its required energy onboard using sealed lead storage batteries, these are used to filter the mains electrical input before outputting a clean supply without spikes and is powered by 6v cells, and comes with 2 x 6-volt batteries which is what the offer on this page is, they are of course recyclable the main component in them is lead meaning that they are a environmentally friendly form of protection that can be made into something else when the time comes for recycling, and by fitting them in your machine you are prolonging the life of this equipment which is also a bonus rather than it ending on land fill, and why not there are many years of life left in it yet.
- APC AP200 battery replacement
Installing the batteries in not a difficult job, well within the capabilities of most people, you should refer to your manual for the method, they are designed to be replaced, the ones we send to you will be almost fully charged but the UPS will still complete a service charge upon installation, you should note that while this is going on you will not have the full runtime protection, if you have the opportunity it will be best to run the system without a load to start so it can properly reset itself to the new energy level
It would be fair to expect batteries to last somewhere between two to five years in this UPS, how it's used however will determine this, supplying adequate ventilation is important, the batteries are being continuously used the hotter they get the shorter the life span, also do not overload with to many devices, if you can keep the load below 40%, while the system may be of going higher than that its working the battery cell harder which means a shorter life span
The battery cells are constructed from absorbed glass mat technology or AGM, they are also valve regulated sealed lead acid or VRLA, this is the recommended type of battery for this installation, they will not leak if mounted on the side so safe to be used in a UPS tower or rack mountable configuration with fear of spillage in mission critical applications like a hospital or busy data centre as well as the home office
We have provided the information here as a guide, you should carefully check the code on your UPS as many of them are very similar so it's easy to make a mistake, the batteries are recyclable, more information about recycling can be found on our recycling page, link to which is at the foot of this page
Voltage = 6-volts
Capacity = 4.5Ah @20Hr
Chemistry = AGM, sealed lead, VRLA
Hot swap capable
This offer is for a total of 2 rechargeable lead acid batteries for the APC AP200 the physical dimensions of each battery is
Length = 70mm
Width = 48mm
Height = 102mm
Battery layout - from chart below = 1
