Eaton Powerware Prestige 6000 EXT UPS battery pack replacement.
Replacement Eaton Powerware Prestige 6000 EXT non-spillable sealed lead acid valve regulated UPS system batteries, AGM and VRLA that can be mounted on its side offered direct from warehouse at low cost.
Below is the details of the batteries your will require to replace in your UPS system for the Eaton Powerware Prestige 6000 EXT, the system uses batteries to filter the input electricity and output a clean supply to protect your equipment behind it they are 12v cells, and comes with 20 x 12-volt batteries and that is what this offer is for which of course are rechargeable they are safe non-spillable AGM and VRLA type batteries, more information about the chemical make-up of them will be found below.
- Eaton Powerware Prestige 6000 EXT battery replacement
The batteries will come out to you almost fully charged, but the system will still want to finish off the full charge, during this period you should note that your system will not be able to offer you its full runtime protection until it has finished this task, if you can its best to do this initial charge without any load, we know this may not be convenient in a lot of installations but that is best advise.
You would expect these kind of batteries to last between two to five years in this kind of device, this will be very dependent on the use and the way the system is stored, ensure there is always good ventilations around the device, do not allow it to be used as a filing cabinet, if the batteries overheat it shortens the life span, also do not overload, if you can keep the load below 40%, while the system will be more than capable of going higher than that it pays the price of working the battery cell harder which means a shorter life span.
The cells are absorbed glass mat or AGM, they are also valve regulated sealed lead acid or VRLA, this is the recommended type of battery for this installation, they will not leak if mounted on the side so safe to be used in tower or rack mountable configuration with fear of spillage in mission critical applications as well as the home office.
Please note that the information on this page is only a guide, we have tried to assist you in getting the correct batteries for your UPS system, if you are not sure you can always check what you have before ordering, this will also give you the opportunity to see how easy it is going to be to change the batteries, if you look closely at the product code on your UPS then you shouldn't go wrong.
Voltage = 12-volts
Capacity = 18Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
This offer is for a total of 20 quality lead acid batteries for the Eaton Powerware Prestige 6000 EXT the overall size of the batteries are
Length = 181mm
Width = 76mm
Height = 167mm
Hot swap capable, no maintenance required
