Eaton Powerware PW5119-3000 UPS battery pack replacement VRLA
Replacement Eaton Powerware PW5119-3000 rechargeable battery pack, valve regulated VRLA sealed AGM, safe non-spillable batteries for this UPS system direct from warehouse at low price

The following information are details to be used for replacement batteries for the Eaton Powerware PW5119-3000, the energy that is required for functioning is stored directly onboard it takes the mains supply and passes it through the batteries and is powered by 12v cells, and comes with 4 x 12-volt batteries and that is what this offer is for, as you would expect they are rechargeable and as they are also recyclable to give them a long life and of course environmentally friendly, more information on recycling can be found on our recycle page

• Eaton Powerware PW5119-3000 battery replacement

We will send you batteries that are almost fully charged, your UPS will finish off the charge which helps it reset to the battery cell itself, with this in mind it will mean that there is a period of time that the system is unable to offer full runtime protection while it is doing this, while it may not be convenient it is best to run without load to start so it can fully reset itself to the new energy level

Batteries in this kind of installation will have a life span of between 2 to five years, this will however will vary greatly depending on the conditions or storage and overall use, good ventilation, if it's in a office do not use it as a book shelf, keeping the load low will extend the life span, in a ideal world below 40%, they are so often run to the edge of their capabilities, while they may be able to do it its reducing the life span

The battery type is AGM or absorbed glass mat construction, they are also valve regulated, they can be used in tower or rack mounted UPS systems without any fear of leakage, they require no maintenance throughout the life span and are not-hazardous so safe for use indoors, the expected life span

Check the code on your UPS to ensure you are ordering the correct battery set, the size of the batteries are also specified below if you are unsure, many of the codes on UPS systems are similar

Voltage = 12-volts
Capacity = 18Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable

In this pack there is 4 ready to install batteries for the Eaton Powerware PW5119-3000 the physical dimensions of each battery is
Length = 181mm
Width = 76mm
Height = 167mm
Battery layout - from chart below = 0

Hot swap capable, no maintenance required