APC Back-UPS BE500 replacement UPS battery set AGM sealed lead
Replacement APC Back-UPS BE500 batteries, rechargeable valve regulated sealed lead non-spillable UPS battery backup power pack at low competitive price direct from warehouse

Here you will find we have detailed the information to help you make the decision of purchasing a new set of batteries for your APC Back-UPS BE500, it stores its required energy onboard using sealed lead storage batteries, these are used to filter the mains electrical input before outputting a clean supply without spikes and is powered by 12v cells, and comes with 1 x 12-volt batteries which is what the offer on this page is which are as required rechargeable, they are safe, not-hazardous and will not spill, they are working hard the entire time the equipment is switched so they do a lot of work over the years

• APC Back-UPS BE500 battery replacement

The new batteries that you receive from us will be almost fully charged but the system will still need to complete a service charge upon installation, you should note that while this is going on you will not have the full runtime protection, we know it is probably urgently being used but its best to run without a load to start so it can reset itself

It may be reasonable to expect two to five years from your new batteries in this UPS, how it's used however will determine this, ensure there is adequate ventilation around the device, do not block the vents, do not allow it to be used as a shelf to put files on, if the batteries overheat it shortens the life span, keep an eye on the load, do not have to many devices connected, if you can keep it below 40% it will last longer, while its more than capable of going higher it will be at the expense of the battery life

These batteries are sealed lead valve regulated or VRLA and benefit from AGM technology, this means they will not spill so can be mounted on the side in a UPS without fear of leakage, they can be used in rack or tower modules, they are not-hazardous so safe for use in mission critical environments including busy data centres or hospitals

Check the code on your UPS to ensure you are ordering the correct battery set, many codes are very similar, the size of the batteries are also specified below if you are unsure, the batteries are recyclable, more information about recycling can be found at the foot of this page.

Voltage = 12-volts
Capacity = 4.5Ah @20Hr
Chemistry = absorbed glass mat, AGM, VRLA
Hot swap capable

we are offering 1 ready to install batteries for the APC Back-UPS BE500 the overall dimensions of each battery are
Length = 90mm
Width = 70mm
Height = 101mm
Battery layout - from chart below = 1