APC Back-UPS 200, BK200 battery pack sealed lead VRLA AGM
Replacement battery pack for the APC BACK-UPS 200 BK200, rechargeable VRLA AGM sealed lead batteries at low price
The APC Backs-UPS BK200 is a small uninterruptible power supply that offers surge protection form electrical mains that can damage sensitive equipment, you will often find this UPS on desktops protecting computers and even this like tills or point of sale devices
- APC BK200 battery
- APC Backs-UPS 200 battery
This pack is for ON 12-volt sealed lead battery rated at 7 amp, it is sealed so it can be mounted on its side with no fear of spillage and requires no maintenance.
Please note that the BK200 and BK200B may have 2 different battery configurations, before ordering you should open the cover, if it has 1 battery in it then this is the correct pack you will require, if however it has 2 batteries then you need a RBC1 pack, you will find a link to them further down this page
Our best advise after fitting is to power it up without any load for it to completely reset itself to the new battery, give it sufficient time to fully charge itself
Voltage - 12-volt
Capacity 7Ah @20 hr
There is 1 battery as required in this pack for the APC Backs-UPS 200 BK200, the size of it is as follows
Length - 151mm
Width - 65mm
Height 94mm
Further down this page you will find a link to a 9ah battery, this will replace the one on this page for a longer runtime, and as its the same size a very easy upgrade. Also if you have the 2 battery configuration Backs-UPS 200 a link to the RBC1 batteries to fit it.
